Abstract:International Journal of Protective Structures, Ahead of Print. Nowadays, accidental explosions in residential and factory buildings are common owing to poor maintenance and mishandling of fuel gas and chemical explosive appliances leading to grievous injuries and infrastructure damages. Contact blast on slabs using explosives is noticed as a simpler act of subversion as compared to other components of the building and is more damaging than a close-in blast. In general, damage caused by contact blast is localized in the form of concrete cratering, scabbing, and rupture of the reinforcement. A recently published state-of-the-art review on the performance of reinforced concrete (RC) slabs under contact and close-in explosion loading scenario by the authors (Anas et al., 2021b) reveals the common perception for the location of contact blast to cause maximum damage is the centroid of the slab. It develops a curiosity with sufficient interest to investigate the effect of the location of contact explosive charge on the damage response of the slab. Several numerical techniques such as empirical, ConWEP (semi-empirical), Smooth Particle Hydrodynamics (mesh-free method), and Coupled-Eulerian-Lagrangian (CEL) are in use for simulation of blast loading on structures. Current literature reveals that the CEL is the most advanced and realistic blast modeling technique. This study applies Coupled-Eulerian–Lagrangian (CEL) formulation with finite element method (FEM) using the dynamic computer code ABAQUS/Explicit-v.6.15 to investigate the performance of singly reinforced one-way spanning concrete slab subjected to concentric contact blast loading. The numerical model is validated with the experiment results in the open literature. The validated model is then employed to investigate whether or not the maximum damage is really caused by the central location of the contact blast. For this purpose, one-quarter of the slab with nine symmetrical points (or locations) of contact blast of explosive charge, which reflect the coverage of the entire slab, in contact with the top face of the slab is considered in the study. Two constitutive material models, Concrete Damage Plasticity and Johnson–Cook, with strain rate effects are used to simulate the non-linear behavior of the concrete and steel, respectively. The results reveal that the most critical location of maximum damage to the slab is along the line of symmetry parallel to the supports at an eccentricity of B/4 from the centroid of the slab, where "B" is the width of the one-way slab.

Simulation of Reinforced Concrete Slabs in Residential Buildings Under Internal Gas Blast

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Numerical simulation of blast resistance of reinforced concrete slabs under fire conditions

PREDICTION OF DEBRIS LAUNCH VELOCITY OF REINFORCED CONCRETE SLAB SUBJECTED TO INTERNAL BLAST LOADING

Blast Resistance of Reinforced Concrete Slabs Based on Residual Load-Bearing Capacity

Performance of One-way Composite Reinforced Concrete Slabs under Explosive-induced Blast Loading

Numerical analysis of reinforced concrete buildings subjected to blast load

Experimental and Numerical Study on the Dynamic Response of RC Slabs under Blast Loading

Dynamic Response of Reinforced Concrete Slab Subjected to Internal Blast Loading

Spallation Mechanism of RC Slabs under Contact Detonation

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Damage Mechanism and Mode of Square Reinforced Concrete Slab Subjected to Blast Loading

Evaluation of critical damage location of contact blast on conventionally reinforced one-way square concrete slab applying CEL-FEM blast modeling technique

Blast resistant capacity of reinforced concrete slab based on experiment and equivalent single degree of freedom method

Experimental and Numerical Study of Non-Explosive Simulated Blast Loading on Reinforced Concrete Slabs

Evaluating concrete material models for blast analysis using 3D finite element analysis

Analysis for Blast Resistance and Damage Mode of Reinforced Concrete Slab Subjected to Explosive Load

Blast Resistance of Small-Scale RCS in Experimental Test and Numerical Analysis

Experimental study and numerical simulation of the damage mode of a square reinforced concrete slab under close-in explosion

Finite Element Simulation of FRP Strengthened Reinforced Concrete Slabs under Two Independent Air Blasts