Abstract:Abstract This paper describes the work conducted by the Canadian Nuclear Safety Commission (CNSC) related to the numerical simulations of reinforced concrete (RC) structures under deformable missile impact. The current paper is a continuation of the work conducted in the frame of the OECD/NEA* IRIS (Improving Robustness Assessment Methodologies for Structures Impacted by Missiles) Phase 3 benchmark project. The concrete mock-up with two simple structures attached, one welded and another bolted, was built and tested at the VTT Technical Research Centre in Espoo, Finland. This mock-up was impacted by three subsequent missiles with varying velocities in order to obtain the damage accumulation. To examine vibration transmission through the mock-up, the simple structures modelling equipment were attached to the rear wall of the structure, while the missile impact was at the centre of the front wall. The parameters of the missiles and the RC structure were selected to ensure a flexible behaviour of the RC target in the impact area with only moderate damages, specifically cracking and permanent deformation without perforation. The non-linear dynamic behaviour of the reinforced concrete slabs under missile impact was analyzed using the commercial FE code LS-DYNA. A hybrid FE model using both 3-D solid and 2-D shell FE models was developed for the target discretization. Since the ultimate objective of this work is to model the entire structure over long time periods, a simplified combined shell-solid model with distributed (smeared) reinforcement was selected and validated. This model employs solid FE around an impact area and shell FE for the rest of the mock-up. Detailed modelling of a large RC structure with all equipment attached leads to a very large finite element (FE) model. Therefore, two-level FE modelling using sub-modelling approach was employed: first, analyze the vibrations of a reinforced concrete structure with simplified equipment modelling, and second, analyze in detail the equipment connected to it. This approach assumes uncoupled dynamic behaviour of the structure and the equipment. While the sub-modelling technique is commonly used in static analysis, a special sensitivity analysis was conducted to prove the applicability of sub-modelling for impact analysis. Finally, the effect of structural damping was examined and the best possible damping was selected. The selected damping values and sub-models resulted in relatively good agreement with the test results for both global (RC mock-up) and local (equipment) behaviour.

Kinetic response of reinforced concrete slabs to high-velocity projectile impact-robust numerical and statistical driven modeling techniques

Finite Element Modelling of Two-way RC Slabs with Varying Modelling Choices

PREDICTION OF DEBRIS LAUNCH VELOCITY OF REINFORCED CONCRETE SLAB SUBJECTED TO INTERNAL BLAST LOADING

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Spallation Mechanism of RC Slabs under Contact Detonation

Influence of Supports on the Low-Velocity Impact Response of Square RC Slab of Standard Concrete and Ultra-High Performance Concrete: FEM-Based Computational Analysis

Dynamic Response of the 300Mm-Diameter Projectile Impacting RC Slab

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

Numerical analysis of reinforced concrete beams subjected to impact loads

Failure Modes Behavior of Different Strengthening Types of RC Slabs Subjected to Low-Velocity Impact Loading: A Review

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Numerical simulation of blast resistance of reinforced concrete slabs under fire conditions

Investigation on Anti-Explosion Performance of Reinforced Concrete Slab with Composite Protective Aluminum Foam

Dynamic Response of Reinforced Concrete Slab Subjected to Internal Blast Loading

Reinforced concrete structures under hard projectile impact: penetration and perforation resistance

Performance of One-way Composite Reinforced Concrete Slabs under Explosive-induced Blast Loading

Simulation of Reinforced Concrete Slabs in Residential Buildings Under Internal Gas Blast

Dynamic Response and Shear Demand of Reinforced Concrete Beams Subjected to Impact Loading

Applicability of Sub-Modelling Technique for Dynamic Analysis of Concrete Structures With Attached Equipment Under Missile Impact

Impact Response of Reinforced Concrete Beam and Its Analytical Evaluation

An experimental investigation of plain, reinforced, and prestressed concrete slabs subjected to non-deformable projectile impact