Abstract:This manuscript reports an approach for additive manufacturing of complex functionally‐graded metallic components via laser powder bed fusion, where the composition and volume fractions of the phases are locally tuned via spatial modulation of the processing parameters. Hybrid structures made of 17‐4PH steel, with local variations of ~20% in strength and ~150% in ductility are demonstrated. The established approach to materials design for additive manufacturing (AM) consists of attempting to reproduce the uniform structures and properties of conventionally processed materials. While this certainly helped facilitate material certification and the rapid introduction of AM technologies in several industries, the opportunity to exploit unique features of specific AM processes to generate spatially varying microstructures–and hence novel materials, remains largely untapped. This work presents a method for manufacturing materials through laser powder bed fusion (LPBF), in which control over the spatial variation in phase composition and mechanical properties is achieved. This technique is demonstrated using 17‐4 precipitation‐hardened stainless steel (17‐4PH), by controlling spatial modulation of energy densities during printing. This results in local control of ferrite/martensite volume fractions, allowing the fabrication of metal/metal architected composites with hard/brittle regions interspersed with soft/tough regions. Local variations of ~20% in tensile strength and ~150% in elongation are achieved, with a spatial resolution of ~100 microns. The approach is general and robust, fully compatible with commercially available LPBF equipment, and applicable to virtually any multi‐phase alloy system. This work shifts the paradigm from attempting to print components with uniform properties to manufacturing alloys with controlled spatial property gradients.

Microstructure tailoring in laser powder bed fusion (L-PBF): Strategies, challenges, and future outlooks

Process-structure-property Modeling for Postbuild Heat Treatment of Powder Bed Fusion Ti-6Al-4V

Formation mechanisms and control strategies of metallurgical defects and microstructures during laser powder bed fusion of AlSi10Mg lattice structures

Characterization, preparation, and reuse of metallic powders for laser powder bed fusion: A review

Pore defects in Laser Powder Bed Fusion: Formation mechanism, control method, and perspectives

Research Status of Laser Powder Bed Fusion Al–Li Alloys and Its Improvement Measures

Recent progress on additive manufacturing of multi-material structures with laser powder bed fusion

Recent progress on the control strategies of microstructure and mechanical properties of LPBF-printed aluminum alloys

Laser Powder Bed Fusion of Dissimilar Metal Materials: A Review

Laser Powder Bed Fusion of Powder Material: A Review

Review on the correlation between microstructure and mechanical performance for laser powder bed fusion AlSi10Mg

Unveiling the impact of layerwise laser preheating on microstructure and mechanical response in laser powder bed fusion

Heterogeneous structures in a Ni-based superalloy with tailoring mechanical properties produced by a twin laser powder bed fusion system

Alloy design for laser powder bed fusion additive manufacturing: a critical review

Developing ductile and isotropic Ti alloy with tailored composition for laser powder bed fusion

Microstructural Control of a Multi‐Phase PH Steel Printed with Laser Powder Bed Fusion

Machine-Learning Assisted Laser Powder Bed Fusion Process Optimization for AlSi10mg: New Microstructure Description Indices and Fracture Mechanisms

Microstructural control in metal laser powder bed fusion additive manufacturing using laser beam shaping strategy

The interplay of local chemistry and plasticity in controlling microstructure formation during laser powder bed fusion of metals

Laser Powder Bed Fusion of Titanium Aluminides: An Investigation on Site-Specific Microstructure Evolution Mechanism

Laser Powder Bed Fusion: A State-of-the-Art Review of the Technology, Materials, Properties & Defects, and Numerical Modelling