Channel formation characteristics under the influence of tool design and comparative analysis on friction stir channeling between copper and aluminum materials

Milap Pandya,Nirav P. Patel,Kush P. Mehta

DOI: https://doi.org/10.1016/j.cirpj.2024.01.002

IF: 4.8

2024-01-27

CIRP Journal of Manufacturing Science and Technology

Abstract:Manufacturing for next-generation thermal management is very important for electrical and electronics industries to meet sustainable development goals through electrification. In this study, thermal management manufacturing application and analysis of channel formation characteristics for copper and aluminum materials are investigated using different tool designs consisting of three probe thread pitches and four process pitches of the Friction Stir Channeling (FSC) process. Channel characteristics such as shape, area, perimeter, and closing angle are investigated. Analysis of microstructure around the channel using optical microscopy and electron beam scattered diffraction, Vickers hardness measurements at channel cross-section, surface features, and roughness inside channels are conducted. Eventually, the FSCed channels are evaluated for thermal efficiency performance. Complex materials flow with the combined effect of materials extraction and forging through stirring followed by shearing action is revealed as the channel formation mechanism in FSC. The higher thread pitch on the tool probe resulted in non-uniform material flow during channel formation and eventually formed non-rectangular channels. At the interface of the ceiling zone-unprocessed region in copper, intriguing features of piling up grain boundaries, low angle grain boundaries, and higher kernel average misorientation are observed. Unique surface roughness textures are noticed for four different walls of channels in copper and aluminum. The aluminum channel's root mean square roughness (R q ) value is 63.4% rougher on the retreating side and 246% rougher on the ceiling side compared to the copper channel at the same location. The channel produced by the 1.5 mm thread pitch tool was found to be the most efficient in terms of cooling power for both copper and aluminum materials. For Channels fabricated by thread pitches of 1.0 mm, 1.5 mm, and 2.0 mm in copper were found to be 62.4%, 67.3%, and 82.9% more efficient than aluminum channels.

engineering, manufacturing