A. Alekou,E. Baussan,A. K. Bhattacharyya,N. Blaskovic Kraljevic,M. Blennow,M. Bogomilov,B. Bolling,E. Bouquerel,O. Buchan,A. Burgman,C. J. Carlile,J. Cederkall,P. Christiansen,M. Collins,E. Cristaldo Morales,P. Cupiał,L. D’Alessi,H. Danared,D. Dancila,J. P. A. M. de André,J. P. Delahaye,M. Dracos,I. Efthymiopoulos,T. Ekelöf,M. Eshraqi,G. Fanourakis,A. Farricker,E. Fernandez-Martinez,B. Folsom,T. Fukuda,N. Gazis,B. Gålnander,Th. Geralis,M. Ghosh,G. Gokbulut,L. Halić,M. Jenssen,A. Kayis Topaksu,B. Kildetoft,B. Kliček,M. Kozioł,K. Krhač,Ł. Łacny,M. Lindroos,C. Maiano,C. Marrelli,C. Martins,M. Mezzetto,N. Milas,M. Oglakci,T. Ohlsson,M. Olvegård,T. Ota,J. Park,D. Patrzalek,G. Petkov,P. Poussot,R. Johansson,S. Rosauro-Alcaraz,D. Saiang,B. Szybiński,J. Snamina,G. Stavropoulos,M. Stipčević,R. Tarkeshian,F. Terranova,J. Thomas,T. Tolba,E. Trachanas,R. Tsenov,G. Vankova-Kirilova,N. Vassilopoulos,E. Wildner,J. Wurtz,O. Zormpa,Y. Zou

Abstract:A design study, named for European Spallation Source neutrino Super Beam, has been carried out during the years 2018–2022 of how the 5 MW proton linear accelerator of the European Spallation Source under construction in Lund, Sweden, can be used to produce the world's most intense long-baseline neutrino beam. The high beam intensity will allow for measuring the neutrino oscillations near the second oscillation maximum at which the CP violation signal is close to three times higher than at the first maximum, where other experiments measure. This will enable CP violation discovery in the leptonic sector for a wider range of values of the CP violating phase and, in particular, a higher precision measurement of . The present Conceptual Design Report describes the results of the design study of the required upgrade of the ESS linac, of the accumulator ring used to compress the linac pulses from 2.86 ms to 1.2 μs, and of the target station, where the 5 MW proton beam is used to produce the intense neutrino beam. It also presents the design of the near detector, which is used to monitor the neutrino beam as well as to measure neutrino cross sections, and of the large underground far detector located 360 km from ESS, where the magnitude of the oscillation appearance of from is measured. The physics performance of the research facility has been evaluated demonstrating that after 10 years of data-taking, leptonic CP violation can be detected with more than 5 standard deviation significance over 70% of the range of values that the CP violation phase angle can take and that can be measured with a standard error less than 8° irrespective of the measured value of . These results demonstrate the uniquely high physics performance of the proposed research facility.

THE ESS SUPERCONDUCTING LINEAR ACCELERATOR

LLRF System for the ESS Proton Accelerator

Development of high intensity neutron source at the European Spallation Source

The European Spallation Source neutrino super-beam conceptual design report

Pulsed Superconductivity Acceleration

Superstructures For High Current Fel Application

Cavity Simulator for European Spallation Source

STATUS OF THE SUPERCONDUCTING PROTON LINAC (SPL) CRYO- MODULE

The opportunity offered by the ESSnuSB project to exploit the larger leptonic CP violation signal at the second oscillation maximum and the requirements of this project on the ESS accelerator complex

Particle Physics at the European Spallation Source

The HighNESS Project at the European Spallation Source: Current Status and Future Perspectives

High Power Superconducting Electron Linear Accelerators For Industrial Application

Ultra-Compact Ka-band linearizer for the Ultra-Compact X-Ray Free-Electron Laser at UCLA

A SW Ka-Band Linearizer Structure with Minimum Surface Electric Field for the Compact Light XLS Project

An Overview of the Spallation Neutron Source Project

High Temperature Superconducting Magnets for Efficient Low Energy Beam Transport Systems

THE R&D STATUS OF SSC LINAC

Optimisation of klystron operational efficiency at ESS

High duty factor plasma generator for CERN's Superconducting Proton Linac

The FEL in the SXL project at MAX IV

Accelerator Development at the FREIA Laboratory