Abstract:Diamond has great potential applications in high-power, high-frequency semiconductor devices because of its wide band gap (5.5 eV), high thermal conductivity (22W/(cm·K)), and high carrier mobility (4500 cm2/(V·s) for electron, and 3800 cm2/(V·s) for hole). It has been widely considered as an ultimate semiconductor. From the analysis of our previous work, we find that the output current of field effect transistor based on hydrogen-terminated polycrystalline diamond is usually larger than that based on single crystal diamond, and that the preferential orientations of the polycrystalline diamond are mainly \begin{document}$ \langle 110\rangle $\end{document} and \begin{document}$ \langle 111\rangle $\end{document} shown by XRD results. Therefore, in order to further analyze the effect of surface orientation on the device performance of hydrogen-terminated diamond field effect transistor (FET), we study the devices fabricated respectively on the (110) plane and (111) plane single crystal diamond plates obtained from a single 3.5-mm-thick single crystal diamond grown by the microwave plasma chemical vapor deposition on the high-pressure high-temperature synthesized diamond substrate. Prior to processing the device, these diamond plates are characterized by atomic force microscope, Raman spectra and photoluminescence (PL) spectra. The results of Raman and PL spectra show that (110) plane and (111) plane plates originating from the same CVD single crystal diamond have no significant difference in optical property. Then the normally-on hydrogen-terminated diamond FET with a gate length of 6 μm is achieved. The device on (111) plane delivers a saturation drain current of 80.41 mA/mm at a gate voltage VGS = –4 V, which is approximately 1.4 times that of the device on (110) plane. Meanwhile, the on-resistance of the device on (111) plane is 48.51 Ω·mm, and it is only 67% of the device on (110) plane. Analyses of the capacitance-voltage show that the hole concentration of the gated device on (110) plane and (111) plane are 1.34 × 1013 cm–2 and 1.45 × 1013 cm–2, respectively, approximately at the same level. In addition, the hole density of the device on both (110) and (111) plane increase near-linearly with the increase of gate voltage from the threshold voltage to – 4 V, indicating that the control effect of the gate on the carrier in the channel is uniform. The possible reason for the higher saturation drain current as well as the lower on-resistance of the device on (111) plane is that its sheet resistance is lower.

Vertical 3D diamond field effect transistors with nanoscale gate-all-around

Monolithic Three‐dimensional Integration of Aligned Carbon Nanotube Transistors for High‐performance Integrated Circuits

Ultrahigh On/Off Ratio (110) Diamond Transistors with Exceptional Reproducibility of Normally Off Characteristics

Vertical-type two-dimensional hole gas diamond metal oxide semiconductor field-effect transistors

Over 1 A Operation of Vertical-Type Diamond MOSFETs

Three-dimensional Vertical ZnO Transistors with Suspended Top Electrodes Fabricated by Focused Ion Beam Technology

A Field Effect Transistor Using Highly Nitrogen-Doped CVD Diamond for Power Device Applications

The synergistic effect of vertical structural parameters of vertical-type two-dimensional hole gas diamond MOSFETs on improving the overall performance of devices based on TCAD simulation

III&#x2013;V 4D Transistors

High performance ionic-liquid-gated air doped diamond field-effect transistors

High-Mobility p-Channel Wide Bandgap Transistors Based on h-BN/Diamond Heterostructures

Over 50 mA current in interdigitated diamond field effect transistor

III-V Gate-all-around Nanowire MOSFET Process Technology: from 3D to 4D

Characteristics of H-terminated Single Crystalline Diamond Field Effect Transistors

Diamond lateral FinFET with triode-like behavior

High-performance III-V MOSFET with Nano-Stacked High-K Gate Dielectric and 3D Fin-Shaped Structure

Characteristics of Hydrogen-Terminated Single Crystalline Diamond Field Effect Transistors with Different Surface Orientations

High-mobility p-channel wide-bandgap transistors based on hydrogen-terminated diamond/hexagonal boron nitride heterostructures

High-mobility diamond field effect transistor with a monocrystalline h-BN gate dielectric

A Vertical Silicon-Graphene-germanium Transistor.

High Performance of Normally‐On and Normally‐Off Devices with Highly Boron‐Doped Source and Drain on H‐Terminated Polycrystalline Diamond