Abstract:The existence of surface plasmon polaritons in doped silicon micro-scale structures has opened up new and innovative possibilities for applications, such as sensing, imaging, and photonics. A CMOS-compatible doped Si plasmonic sensor is proposed and investigated. The plasmon resonance can be tuned by controlling the carrier density and dopant concentration. In this paper, we demonstrate that using silicon doped with phosphorus at a concentration of 5 × 1020 cm-3 can induce surface plasmon resonance in the mid-infrared region. Two ring resonators of two different radii based on metal-insulator-metal waveguide structures are studied individually. Then, the two ring resonators are integrated in the same device. When the two ring resonators are coupled and resonate at the same frequency; two distinct resonance spectral lines are generated with striking features that improve its potential use for sensing and modulation applications. The propagating plasmonic mode is studied, including its mode profile and bend loss. We evaluate the effectiveness of a microstructure gas sensor with dimensions of 15 μm × 15 μm by measuring its sensitivity and selectivity towards methane and ethane gases. Small alterations in the surrounding refractive index led to noticeable shifts in the resonance peak. The sensor achieved a sensitivity of 7539.9 nm/RIU at the mid-infrared spectral range around the 7.7 μm wavelength. Furthermore, by combining the resonators, we can achieve a smaller full width at half maximum (FWHM), which will ultimately result in greater sensitivity than using a single-ring resonator or other plasmonic resonator configurations. Once the sensitivity and selectivity of the sensor are measured, the FOM can be calculated by dividing the sensitivity by the selectivity of the sensor, resulting in an FOM of 6732.

Gas Sensing Through Mixed Polarization in Birefringent Porous Silicon Thin Film

A Two-Dimensional Polarization Interferometry Based Parallel Scan Angular Surface Plasmon Resonance Biosensor

Polarization-interferometry-based Wavelength-Interrogation Surface Plasmon Resonance Imager for Analysis of Microarrays

Polarization interference interrogation of angular surface plasmon resonance sensors with wide metal film thickness tolerance

An Integrated Optical Sensor Based on Cascaded Polarization Convertor and Slot Waveguide Microring Resonator

Nanoscale morphology, optical dynamics and gas sensor of porous silicon

Single-Shot Quantitative Polarization Imaging of Complex Birefringent Structure Dynamics

Polarization-resolved sensing with tilted fiber Bragg gratings: theory and limits of detection

Rigorous Design Optimization of a Fiber-Enabled Polarimetric Waveguide Interferometer for Biosensing

Coupling phase-switching with generalized Brewster effect for tunable optical sensor designs

Distributed opto-mechanical analysis of liquids outside standard fibers coated with polyimide

Polarimetric compressed sensing with hollow, self-assembled diffractive films

Anisotropic medium sensing controlled by bound states in the continuum in polarization-independent metasurfaces

New photonic architectures for mid-infrared gas sensors integrated on silicon

Ordered-Mesoporous-Silica-Thin-Film-Based Chemical Gas Sensors with Integrated Optical Polarimetric Interferometry

Integrated Dual Grating Polymer Microbeams for Bio-Chemical Sensing in Liquid Environment

Transparent Anisotropic Films Measurement with a Polarized Angle-Resolved Spectroscopy

Polarization Maintaining Fiber Temperature and Stress Gradient Sensitization Sensor Based on Semiconductor-Metal–Polymer Three-Layer Film Coating

Polarization-resolved surface-enhanced infrared spectra with nanosensors based on self-organized gold nanorods

Mid-Infrared Gas Sensing Based on Electromagnetically Induced Transparency in Coupled Plasmonic Resonators

Design and numerical analysis of a novel dual-polarized refractive index sensor based on D-shaped photonic crystal fiber