Abstract:Due to the interactions between disks during the vibration process, the maximum deformation may occur after the occurrence of maximum electromagnetic force. The hysteresis phenomenon between disk deformation and electromagnetic force is studied in this article. The condition conducive to the formation of the hysteresis phenomenon is that the natural vibration frequency of the winding is close to the electromagnetic force frequency, thus changing the deformation waveform characteristics, causing the maximum vibration intensity to appear at one of the subsequent peaks. Mechanical stability is one of the core capabilities of power transformers. External short‐circuit accidents are the main cause of winding instability. International Electrotechnical Commission 60076‐5 standard recommends a method to calculate the short‐circuit strength of power transformer windings by comparing the stress within windings under the effect of the maximum electromagnetic force with the critical stress of the winding. This method assumes that the maximum deformation will be produced by the maximum electromagnetic force, which corresponds to the first peak of the waveform. However, owing to the interactions between disks during the vibration process, the maximum deformation may occur after the occurrence of the maximum electromagnetic force. The hysteresis phenomenon between disk deformation and electromagnetic force is studied. The definition of the hysteresis phenomenon during the vibration process is first demonstrated, and the mechanism of the hysteresis phenomenon is investigated. The vibration model is established. By decoupling analysis, the conditions for the formation of hysteresis are proposed, and the mechanism of the hysteresis phenomenon is validated by the experiment, which is conducted on a winding sample. In the deformation formula, the term that determines the time‐varying characteristic is found. The waveform‐determining term is the difference between the two cosine components, whose frequencies are the natural vibration frequency and the electromagnetic force frequency. When the two frequencies are close, the maximum deformation lags behind the maximum force, and the hysteresis phenomenon occurs.

A path of power transformers failure under multiple short-circuit impacts

Analysis and Mitigation of Fault-Induced Electromagnetic Force Effect on PM Modules in Integral-Slot Wind Generators

Numerical Investigations for Vibration and Deformation of Power Transformer Windings under Short-Circuit Condition

The occurrence and mechanism of hysteresis between axial deformation and short‐circuit electromagnetic force during the vibration of power transformer windings

Research on Transient Electric Field Distribution of High-Frequency Transformers Based on COMSOL and SIMULINK Co-simulation

Vibration Model of Power Transformer under Short-Circuit Condition

Quantitative Research on Accumulative Effect of Transformer Winding Deformation and Its Influence Degree Based on Time-Frequency Analysis of Vibration Signal

Strongly Coupled Circuit‐Magnetic‐Structural Effect on Winding Vibration Process of Power Transformer

Research on Short-Circuit Vibration of Power Transformer

Electromechanical Catastrophe

Study on the dynamic mechanical properties of winding‐block axial structure considering short circuit strain rate effect

Distributed Vibration Monitoring System for 10 kV-400 kVA 3D Wound Core Transformer under Progressive Short-Circuit Impulses

Experimental Research on Power Transformer Vibration Distribution under Different Winding Defect Conditions

A study of transformer winding vibration using a laser doppler vibrometer

Transformer Winding Fault Detection by Vibration Analysis Methods

Effect of transformer winding mechanical defects, internal and external electrical faults and inrush currents on performance of differential protection

Dynamic Electromagnetic Force Analysis of a Power Transformer with Regulated Windings

Feature Extraction of Mechanical Faults from Phase Variation in Transformer Vibration

Inter-Turn Breakdown Fault Analysis and Winding Structure Optimisation of Winding of Dry-Type Transformers in Wind Farms

A Study Of The Transient Vibration Of Transformer Windings

Comparative analysis of the characteristics of outlet short circuit and winding insulation fault of distribution transformer and its preventive measures