Abstract:Improving the measurement accuracy and minimising the coupling between directions are the keys to researching the compliant six-axis force sensors. The use of a six-axis force sensor to accurately monitor the ground reaction force (GRF) and centre of pressure (COP) during human motion is of great significance in the fields of biomechanics and pathological gait diagnosis. Although complete force information can be obtained using a commercial six-axis force sensor, its high stiffness affects the natural gait and easily leads to human fatigue. A compliant six-axis force sensor based on a flexible optical waveguide is proposed, in which the force and torque of six dimensions are detected by reasonably arranging six modular sensing units, and the mechanical decoupling of some dimensions is realised in theory. For the interdimensional coupling and error caused by machining process factors, as well as the nonlinear relationship between the input and output of the proposed compliant six-axis force sensor, a DE-RBF decoupling algorithm is proposed to decouple the calibration data. Compared with the least squares method (LSM) and the radial basis function (RBF) neural network decoupling algorithm, the obtained type-I errors were reduced by 87.7629%, 43.6265%, respectively, and type-II errors by 35.3312%, 56.9162%, respectively. The decoupling result's maximum type-I and type-II errors were reduced from 7.7125% and 2.7382% in LSM and 3.1029% and 2.8917% in RBF to 0.5916% and 0.9558%, respectively. The measurement accuracy of the compliant six-axis force sensor was significantly higher; however, the time effectiveness of the proposed DE-RBF decoupling algorithm was slightly lower than that of the RBF neural network by 2.47%. In conclusion, the decoupling accuracy and timeliness of the proposed DE-RBF decoupling algorithm can satisfy the requirements of compliant six-axis force sensors to monitor low-frequency biomechanical signals, such as human motion.

Research on Air-Supported Force Measurement Method and Air-Supported Triaxial Force Measurement Platform

Electromechanical co-simulation analysis for contactless positioning and vibration isolation platform

Six-axis Force/Torque Sensor Based on Stewart Platform

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

A Novel Flexible Centralized Force Sensor Based on Tri‐Axis Force Refactoring Method for Arbitrary Force Components Measurement

Multi-scale Modeling for the Stress Analysis of Acrylic Joints in a Hybrid Structure

Prediction Technique and Measuring Device for Coupled Disturbance Forces from Large Equipment in the Spacecraft

Flexible Centralized Tri-Axis Force Sensor based on Capacitance and Intrinsic Resistance of Bump Structure

Precision tilting platform used for static calibration of accelerometers

Measurement of fastening force using dry-coupled ultrasonic waves

Research on elastic deformation compensation system for three axis air bearing platform

Design and Characterization of a T-shaped Two-Axis Force Sensor

Decoupling Principle Analysis and Development of a Parallel Three-Dimensional Force Sensor

Research on the Pose Error Compensation Technology for the Mass and Centroid Measurement of Large-Sized Aircraft Based on Kinematics

Theoretical and experimental study on interface stiffness measurement of rough surface using improved acoustic model

Development and Calibration of Large Deformation-Compliant Six-Axis Force Sensor

Investigation on Surface Forces Measurement Using Force-Balanced MEMS Sensor

Modeling and Compensation of Cross-Axis Coupling in an Electrostatic Accelerometer for Testing the Equivalence Principle

A New Hypersonic Wind Tunnel Force Measurement System to Reduce Additional Bending Moment and Avoid Time-Varying Stiffness

Correction of coupling error in contact-type ultrasonic evaluation of bolt axial stress

A non-destructive measurement method for axial force using torque in connecting bar with joint bearing ends