Abstract:A SHPB experiment of porous sandstone was conducted to discuss the influencing principle of porosity on the energy dissipation of stress wave across dry and saturated porous sandstones. Changes in porosity before and after the SHPB experiment were analyzed by nuclear magnetic resonance. Results show that the number of wave peaks in the T 2 spectrum before and after the impact test of sandstone is unchanged, but the wave peak value corresponding to small pores increases. This result indicates that the sandstone structure remains in the microcrack formation stage because the stress wave energy is adequate only for forming new microcracks but not for tearing pores and increasing pore diameter. Results further show that, at the same porosity, saturated sandstone consumes less energy than dry sandstone. With increased porosity, the energy dissipation of saturated sandstone decreases, whereas that of dry sandstone increases. This phenomenon can be explained based on three aspects. First, according to the fracture mechanics theory, the surface tension of water and Stefan effect significantly hinder crack expansion. Therefore, generating a new surface to dissipate stress wave energy of saturated sandstone is more difficult than that of dry sandstone under the same porosity. Second, during impact loading, saturated sandstone is in a nondrainage state, and its deformation can be viewed approximately as the sum of compressive deformation of sandstone and water. Water has smaller comprehensive deformation than sandstone. The deformation of saturated sandstone decreases with increased porosity, i.e., water content. Plastic deformation and the probability of new cracks decrease, so energy dissipation of saturated sandstone decreases. Third, with increased porosity, the dynamic strength of dry sandstone declines accordingly. Developing new cracks during loading to dissipate stress wave energy as surface energy is easy. Therefore, high porosity causes great energy dissipation.

Undrained SHPB experiments on calcareous sand with different saturation degrees

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Moisture Effects on the Undrained Dynamic Behavior of Calcareous Sand at High Strain Rates

One-dimensional dynamic compressive behavior of dry calcareous sand at high strain rates

Dynamic mechanical response and particle breakage characteristics of calcareous sand

A modified method for estimating the stress state of granular materials in the passive confined pressure SHPB tests

Effects of Strain Rate and Initial Density on the Dynamic Mechanical Behaviour of Dry Calcareous Sand

Permanent Deformation Characteristics of Saturated Sand under Cyclic Loading

Impact response of unsaturated sandy soil under triaxial stress

Effect of Particle Size on High-Strain Rate Response of Sand

Simulation of Split Hopkinson Pressure Bar Tests on Sands with Low Water Content

Particle Shape Influence on the Deformation Resistance of Carbonate Sands under Drained Condition

Cumulative deformations and particle breakage in calcareous sand subjected to drained high-cyclic loading: Experimental investigation

Effect of Water Saturation on Dynamic Behavior of Sandstone after Wetting-Drying Cycles

High-Strain Rate Compressive Behavior of Dry Mason Sand Under Confinement

The Strain Rate Effects of Coral Sand at Different Relative Densities and Moisture Contents

Simulation of Split Hopkinson Pressure Bar Tests on Sands Using the Discrete-Element Method

Experimental investigation on mechanical behavior and particle crushing of calcareous sand retrieved from South China Sea

Water saturation effects on dynamic behavior and microstructure damage of sandstone: Phenomena and mechanisms

Hydromechanical behavior of unsaturated artificially–hydrophobized sand: Compression, shearing, and dilatancy

Effects of Porosity of Dry and Saturated Sandstone on the Energy Dissipation of Stress Wave