Abstract:Extensive research has been conducted on the impact behavior of unsaturated sand at high strain rates. However, achieving the undrained boundary condition remains a persistent challenge, leading to an inconsistent understanding of the dynamic responses of sand with varying saturation degrees. In this study, a novel sleeve designed to conduct split Hopkinson pressure bar (SHPB) tests under undrained boundary conditions. Furthermore, drained SHPB tests were carried out by using the conventional steel sleeve as references. The absolute particle crushing distributions within various size ranges were investigated by utilization of dyed calcareous sand. Results revealed that, for the conventional drained sleeve, the locking-up phenomenon of full saturation sand was only observed at strain rate of 750 s −1 . However, locking-up occurs at all strain rates for undrained sleeve. The locking-up stiffness at strain rate of 1000 s −1 was 1.6 times larger compared to that at strain rate of 500 s −1 and 750 s −1 , respectively. It means that the locking-up stiffness increases with strain rates under the fully undrained boundary conditions. Furthermore, for the drained sleeve, negligible reductions up to 10.8% were observed in measured B r if saturation degrees change from 0 to 100%. In contrast, for the undrained sleeve, the maximum reduction on B r was 47.6% and increases rapidly with increasing strain rates. The particle crushing was more sensitive to saturation degree at higher loading strain rates under undrained boundary conditions. Meanwhile, the particle crushing probability of medium-sized (1.0–1.5 mm) particles decreases with decreasing saturation degrees and increasing strain rate. It leads that the probabilities of particle crushing across various size ranges become more uniformly distributed with lower saturation degree and higher strain rates.

Simulation of Split Hopkinson Pressure Bar Tests on Sands Using the Discrete-Element Method

Modeling of Sand Particle Crushing in Split Hopkinson Pressure Bar Tests Using the Discrete Element Method

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Simulation of Split Hopkinson Pressure Bar Tests on Sands with Low Water Content

DEM Study of the Stress Fields Around the Closed-Ended Displacement Pile Driven in Sand

Effect of Particle Size on High-Strain Rate Response of Sand

A modified method for estimating the stress state of granular materials in the passive confined pressure SHPB tests

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Numerical Simulation of the Rock SHPB Test with a Special Shape Striker Based on the Discrete Element Method

Material behaviour characterisation using SHPB techniques, tests and simulations

Experimental and numerical investigations on the use of polymer Hopkinson pressure bars

Effects of Strain Rate and Initial Density on the Dynamic Mechanical Behaviour of Dry Calcareous Sand

3D Hopkinson bar: new experiments for dynamic testing on soils

Design, development, and calibration of split Hopkinson pressure bar system for Dynamic material characterization of concrete

The Application Development of Experimental Technique of Hopkinson Pressure Bar

Effect of particle size distribution on dynamic properties of cemented coral sand under SHPB impact loading

Application of Numerical Simulation to SHPB Test to Investigate the Dynamic Compressive Behavior of Material with Failure

Dynamic mechanical properties of dry sand under confined compression

Undrained SHPB experiments on calcareous sand with different saturation degrees

High-Strain Rate Compressive Behavior of Dry Mason Sand Under Confinement