Abstract:Sand is extensively used in geotechnical engineering applications due to its abundance in the field. In general, sands are subjected to very low strain rates in most geotechnical engineering applications; however, during air or surface blasts, sands are subjected to high strain rates and their response needs to be studied in detail. The recent years have seen an increase in the usage of split Hopkinson pressure bar (SHPB) device to study the response of sand at very high stresses (on the order of MPa) and strain rates (10~1000/s). Researchers have shown that the particle size in sand influences its mechanical behavior at low strain rates. However, the effect of particle size on the stress-strain response of sand obtained from an SHPB device where particles are subjected to high strain rates is seldom studied. The particle size could also have an influence on the stress-equilibrium condition which needs to be satisfied by the specimen for the stress-strain analysis from the SHPB to be valid. However, the afore mentioned criteria are seldom studied and need to be studied in detail. In the current study, the SHPB device is modelled using a commercial software package LS-DYNA with a coupled finite elements-discrete element method. The sand specimens are modelled using polydisperse (spheres with varying sizes) and monodisperse discrete spheres. These simulations are used to understand the variation of stress-strain response of sand as a function of particle sizes. The study also provides insight into the effect of friction at the boundaries on the stress-strain response of the specimen. The results indicate that the specimen having larger polydisperse spheres provided similar stress-strain response as the specimen having smaller polydisperse spheres. However, the monodisperse specimen provided a softer response compared to the polydisperse specimens.

Simulation of Split Hopkinson Pressure Bar Tests on Sands with Low Water Content

Simulation of Split Hopkinson Pressure Bar Tests on Sands Using the Discrete-Element Method

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Modeling of Sand Particle Crushing in Split Hopkinson Pressure Bar Tests Using the Discrete Element Method

Effect of Particle Size on High-Strain Rate Response of Sand

Numerical Simulation of Centrifuge-Shaking Table Test on Saturated Sand

A modified method for estimating the stress state of granular materials in the passive confined pressure SHPB tests

High-Strain Rate Compressive Behavior of Dry Mason Sand Under Confinement

Application of Numerical Simulation to SHPB Test to Investigate the Dynamic Compressive Behavior of Material with Failure

On the use of SHPB techniques to determine the dynamic behavior of materials in the range of small strains

Effects of Strain Rate and Initial Density on the Dynamic Mechanical Behaviour of Dry Calcareous Sand

Material behaviour characterisation using SHPB techniques, tests and simulations

A theoretical analysis about the influence of interfacial friction in SHPB tests

Numerical Simulation of the Rock SHPB Test with a Special Shape Striker Based on the Discrete Element Method

The Strain Rate Effects of Coral Sand at Different Relative Densities and Moisture Contents

3D Hopkinson bar: new experiments for dynamic testing on soils

Dynamic Triaxial Compression Tests on Sandstone at High Strain Rates and Low Confining Pressures with Split Hopkinson Pressure Bar

A modified triaxial split Hopkinson pressure bar (SHPB) system for quantifying the dynamic compressive response of porous rocks subjected to coupled hydraulic-mechanical loading