Abstract:Methanol as a hydrogen carrier can be reformed with steam over Cu/ZnO/Al2O3 catalysts. In this paper a comprehensive pseudo-homogenous model of a multi-tubular packed-bed reformer has been developed to investigate the impact of operating conditions and geometric parameters on its performance. A kinetic Langmuir-Hinshelwood model of the methanol steam reforming process was proposed. In addition to the kinetic model, the pressure drop and the mass and heat transfer phenomena along the reactor were taken into account. This model was verified by a dynamic model in the platform of ASPEN. The diffusion effect inside catalyst particles was also estimated and accounted for by the effectiveness factor. The simulation results showed axial temperature profiles in both tube and shell side with different operating conditions. Moreover, the lower flow rate of liquid fuel and higher inlet temperature of thermal air led to a lower concentration of residual methanol, but also a higher concentration of generated CO from the reformer exit. The choices of operating conditions were limited to ensure a tolerable concentration of methanol and CO in H2-rich gas for feeding into a high temperature polymer electrolyte membrane fuel cell (HT-PEMFC) stack. With fixed catalyst load, the increase of tube number and decrease of tube diameter improved the methanol conversion, but also increased the CO concentration in reformed gas. In addition, increasing the number of baffle plates in the shell side increased the methanol conversion and the CO concentration.

Stationary and dynamic mathematical modeling of autothermal reforming of diesel with aromatic compounds

A dynamic model for naphtha catalytic reformers

Modeling and Simulation of Commercial Catalytic Reformers

Modeling, Simulation and Optimization of Commercial Naphtha Catalytic Reforming Process

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Lumped Kinetics Model and Its On-Line Application to Commercial Catalytic Naphtha Reforming Process

Modeling, Simulation and Optimization of a Whole Industrial Catalytic Naphtha Reforming Process on Aspen Plus Platform

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Kinetic Modeling of C2–C7 Olefins Interconversion over ZSM-5 Catalyst

Kinetic Model for Hydroisomerization Reaction of C8-aromatics

Modeling and Optimization of Ethane Steam Cracking Process in An Industrial Tubular Reactor with Improved Reaction Scheme

Kinetic Modeling with Automatic Reaction Network Generator, an Application to Naphtha Steam Cracking

Modelling Industrial Catalytic Reforming of Lowoctane Gasoline

Molecular Modeling and Optimization for Catalytic Reforming

Numerical Simulation and Experimental Study on Commercial Diesel Reforming over an Advanced Pt/Rh Three-Way Catalyst

The Real-Time Dynamic Modeling and Simulation of Reforming Moving-Bed Reactor

Multicriteria optimization of gasoline catalytic reforming temperature regime based on a kinetic model with grouped hydrocarbons

Dynamic modelling and simulation for catalytic reforming unit

Modeling and Design of a Multi-Tubular Packed-Bed Reactor for Methanol Steam Reforming over a Cu/ZnO/Al2O3 Catalyst

Two-section reactor model for autothermal reforming of methane to synthesis gas

Numerical Simulation and Experimental Investigation of Diesel Fuel Reforming over a Pt / CeO 2-Al 2 O 3 Catalyst