Effect of Segregation Band on the Microstructure and Properties of a Wind Power Steel before and after Simulated Welding

Xuelin Wang,Xiaoya Wang,Wenle Liu,Chengjia Shang
DOI: https://doi.org/10.3390/met14010129
IF: 2.695
2024-01-22
Metals
Abstract:This article uses scanning electron microscopy (SEM) and electron back-scattering diffraction (EBSD) to study the effect of C and Mn segregation on the microstructure and mechanical properties of high-strength steel with 20 mm thickness used for wind power before and after simulated welding. A Gleeble-3500 (GTC, Dynamic Systems Inc., Poestenkill, NY, USA) was used to study the microstructure evolution of the simulated coarse-grained heat-affected zone (CGHAZ) of experimental steel under different welding heat inputs (10, 14, 20, 30 and 50 kJ/cm) and its relationship with low-temperature impact toughness (−60 °C). The results indicate that alloy element segregation, especially Mn segregation, significantly affects the impact toughness scatter of the steel matrix, as it induces the formation of low-temperature martensite or hard phase, such as M/A (martensite/austenite) constituent. In addition, segregation also reduces the low-temperature impact toughness of the simulated welding samples and increases the fluctuation range. For high-strength steel with yield strength higher than 460 MPa used for wind power generation, there is an optimal welding heat input (~20 kJ/cm), which enables the simulated coarse-grained heat-affected zone (CGHAZ) to obtain the highest impact toughness due to the formation of lath bainite (LB) and the finest crystallographic block units. Excessive or insufficient heat input can induce the formation of coarse granular bainite (GB) or lath martensite (LM), leading to a larger size of crystallographic block units, reducing the hindering effect of brittle crack propagation and deteriorating low-temperature impact toughness.
materials science, multidisciplinary,metallurgy & metallurgical engineering
What problem does this paper attempt to address?
The problem this paper attempts to address is: the study of the effect of alloy element segregation (particularly carbon and manganese) on the microstructure and mechanical properties of high-strength steel used for wind power generation before and after simulated welding. Specifically, the authors investigate the impact of segregation bands on the microstructure and mechanical properties of high-strength steel (with a thickness of 20 mm) using Scanning Electron Microscopy (SEM) and Electron Backscatter Diffraction (EBSD) techniques. They also analyze the microstructural evolution of the simulated coarse-grained heat-affected zone (CGHAZ) under different welding heat input conditions and its relationship with low-temperature impact toughness. The main objectives of the paper include: 1. **Study the impact of segregation bands**: Investigate the effect of carbon and manganese segregation on the microstructure and mechanical properties of high-strength steel, particularly the changes before and after welding. 2. **Optimize welding parameters**: Find the optimal welding heat input conditions to achieve the highest impact toughness in the simulated coarse-grained heat-affected zone. 3. **Elucidate the microscopic mechanisms**: Reveal the relationship between crack propagation paths and crystallographic structural units through microstructural visualization methods, and explain the mechanisms that hinder crack propagation. Through these studies, the authors hope to provide theoretical and experimental basis for the development of high-strength and high-toughness steel for wind power generation.