Abstract:The traditional lattice matched GaInP/(In) GaAs/Ge triple-junction (3J) solar cell has no much room to enhance its practical achievable conversion efficiency because of its inappropriate ensemble of bandgap energies. According to the P-N junction formation mechanism and the close equilibrium condition, we explore a series of computational codes in the framework of MATLAB to simulate and optimize the inverted structure of series-connected 3J solar cells with a fixed top bandgap of 1.90 eV on GaAs substrate. In this paper, structural optimization is conducted in the real device design, because the realistic (QE) is closely related to a set of material parameters in the subcell, i.e., the absorbtion coefficient of material, subcell thickness, minority carrier diffusion length, surface recombination velocity, etc. The results indicate improved inverted 3J solar cells with nearly optimized bandgaps of 1.90, 1.38, and 0.94 eV, by utilizing two independently lattice-mismatches (0.17% and 2.36% misfit respectively) to the GaAs substrate. A theoretical efficiency of 51.25% at 500 suns is demonstrated with this inverted design with the optimal thickness (4 m GaInP top and 3.1 m InGaAs middle). By contrast, the efficiency with the infinite thickness of subcells is reduced by 1%, which is mainly attributed to the effect of minority carrier recombination on Jsc. Exactly speaking, if photo-generated carriers make a contribution to Jsc, they must be collected effectively by the P-N junction before recombining. A new model is proposed based on the effect of dislocation on the metamorphic structure properties by regarding dislocation as minority-carrier recombination center. Our calculation indicates that threading dislocations density in the middle junction is approximate to 1.70105 cm-2 when dislocations in the gradient buffer layer are neglected. The theoretical efficiency is increased by 0.3% compared with the inverted design containing a single metamorphic junction. As a result, based on the two metamorphic combinations, a solar cell with an area of 30.25 mm2 is prepared. The efficiency of the designed cell with two lattice-mismatched junctions reaches 40.01% at 500 suns (AM1.5D, 38.4 W/cm2, 25℃), which is 0.4% higher than that of the single metamorphic junction 3J solar cell.

Sub‐0.6 eV Inverted Metamorphic GaInAs Cells Grown on Inp and GaAs Substrates for Thermophotovoltaics and Laser Power Conversion

Sub-0.6 eV Inverted Metamorphic GaInAs Cells Grown on InP and GaAs Substrates for Thermophotovoltaics and Laser Power Conversion

Three-junction Tandem Photovoltaic Cell for a Wide Temperature Range Based on a Multilayer Circular Truncated Cone Metamaterial Emitter

Fabrication of 0.6 eV Bandgap In0.69Ga0.31As Thermophotovoltaic Cells and Its System Demonstration

Quantum Efficiency and Temperature Coefficients of Gainp/Gaas Dual-Junction Solar Cell

Efficient and scalable GaInAs thermophotovoltaic devices

Ga 0.84 In 0.16 As 0.14 Sb 0.86 /InAs 0.91 Sb 0.09 Dual-Junction Device for Thermophotovoltaic Energy Conversion

Suppression of Phase Separation in AlGaInAs Compositionally Graded Buffers for 1550 nm Photovoltaic Converters on GaAs

Design and characterization of a 53.5% efficient GaInP‐based optical photovoltaic converter under 637 nm laser irradiation at 10 Wcm‐2

High-Voltage 1064 Nm InGaAsP Multijunction Laser Power Converters

67.5% Efficient InP-Based Laser Power Converters at 1470 nm at 77 K

Near-Field Thermophotovoltaic Energy Conversion with Thin-film Tandem Cells

High-efficiency InP-based Multijunction Solar Cells

Analyses of the Effect of Mismatch on the Performance of Inverted GaInP/InxGa1-xAs/InyGa1-yAs Triple-Junction Solar Cells

Improved GaInP/GaAs/GaInAs inverted metamorphic triple-junction solar cells by reduction of Zn diffusion in the top subcell

High-Efficiency 1064 nm Metamorphic Photonic Power Converters for Spacecraft Wireless Power Transfer

Group IV Mid-Infrared Thermophotovoltaic Cells on Silicon

Simple Rectangular Gratings As a Near-Field “Anti-Reflection” Pattern for GaSb TPV Cells

Solution Processed Infrared- and Thermo- Photovoltaics based on 0.7 eV Bandgap PbS Colloidal Quantum Dots

DESIGN AND OPTIMIZATION OF INVERTED METAMORPHIC GaInP/GaAs/InGaAs TRIPLE JUNCTION SOLAR CELL

Photoemission study and band alignment of GaN passivation layers on GaInP heterointerface