Abstract:The paper aims to study on the stress-strain evolution and influencing factors in the JCO forming process of 2205/X65 bimetallic pipe. Based on the finite element modeling of 2205/X65 bimetallic pipe JCO forming process, the stress-strain distribution and evolution of bimetallic pipe were analyzed, and the free bending deformation characteristics of bimetallic plate and the distribution characteristics of interface stress between different materials were obtained. On this basis, the change rules of maximum shear stress with the pressing amount, the lower die span and the die radius were studied. The stress of 2205/X65 bimetallic pipe showed segmented distribution after forming. Except for the last pressing position, the size and distribution of the stresses of the other section of the pipe were the same, and the pipe blank after forming was composed of circular arc section and straight section. The neutral layer of bending of bimetallic plate was closer to the 2205 side of higher yield strength; when the die was pressed to the lowest point, the upper and lower surfaces reached yield state, and the stress at the neutral layer was the minimum; after unloading, the maximum residual stress dis智能焊接与连接专题 2 精密成形工程 2020 年 1 月 tribution was on the middle part of the pipe thickness direction, the hoop stress of the upper and lower surface showed compressive stress distribution. There is a large gradient transition in the interface stress between different materials, and the neutral layer of bimetallic plate is offset to one side of the plate. The maximum shear stress of the 2205/X65 bimetallic pipe increases linearly with the increase of the pressing amount. When the pressing amount is 30 mm, the maximum shear stress reaches the experimentally tested shear strength of the bimetallic plate. The maximum shear stress decreases with the increase of the span of the lower die, increases with the increase of the radius of the upper die, and increases with the increase of the radius of the lower die. The maximum shear stress increases with the increase of the radius of the lower die, but the increase amplitude is small. After the forming, the spring back angle decreases first and then increases and finally stabilizes with the increase of the pressing amount.

Mechanical Expanding Diameter Process of X70 JCOE Pipe

Cracking Analysis on X80 Steel Oil Pipe during JCOE Forming

Yield Strength Development from High Strength Steel Plate to UOE Pipe

The Effect of Microstructure on Properties of High Deformation Pipeline Steel X70

Numerical Simulation of X90 UOE Pipe Forming Process

Integrated finite element simulation and experiment verification of the large-sized straight welded pipe processing with JCOE technology

Numerical Study on the X80 UOE Pipe Forming Process

Tensile Behavior of X70 Pipeline Steel

Research and Application of Edge Plane Shape Control Method of High Grade Pipeline Steel

Finite Element Study on JCO Forming of 2205/X65 Bimetallic Pipeline

Microstructure and Mechanical Properties of J55ERW Steel Pipe Processed by On-Line Spray Water Cooling

Cracking Reasons of X70 Steel Submerged Arc Weld Pipe during Guide-Bend Test

Effect of through-thickness microstructure inhomogeneity on mechanical properties and strain hardening behavior in heavy-wall X70 pipeline steels

Studying the Microstructural Evolution in a Hot-Rolled Thick Gauge Microalloyed Line Pipe Steel

Microstructural Evolution and Mechanical Properties of Reeled X65 Pipeline Steel during Cyclic Plastic Deformation and Natural Aging

Microstructure and mechanical properties of X90 high strength pipeline steel

Effect of Microstructure on Mechanical Properties of X65MS Welded Pipe Joint

Effect of Coiling Temperature on Microstructure and Properties of X100 Pipeline Steel

The Microstructure and Mechanical Property of X70, X80 and X100 Grade Pipeline Steel

Study on Microstructure and Tensile Behavior of X70 Dual-Phase Steel in Different Directions: Experiments and Crystal Plasticity Finite Element Method

Properties of X80 Pipeline Girth Welds for Different Welding Procedures