Abstract:In this paper, a reconfigurable transmitarray unit cell using liquid metal is presented. It consists of three conducting layers where the geometries of the resonators, on the different layers, differ and consist of an arrow shape together with rotated split rings. It is the first time that a transmitarray unit cell, reconfigured employing liquid metal, provides a combination of low insertion loss and large phase shift range. In this paper, a reconfigurable transmitarray unit cell using liquid metal is presented. It consists of three conducting layers where the geometries of the resonators, on the different layers, differ and consist of an arrow shape together with rotated split rings. The arrow‐shaped conducting layer has the capability to convert the polarization of the incoming waves by 90°. The split ring resonators, on the upper and lower conducting layers, have the same dimensions but different orientations (horizontal and vertical polarization). Several fluidic channels are placed beneath/above the conducting layers. The transmission behaviour of the unit cell can be changed by altering the geometrical parameters which is achieved by injecting the liquid metal into the channels. More than 300° phase shift range with a maximum S21 of ∼ −1.5 dB at 3.3 GHz is obtained. It exhibits 3 dB of insertion loss over a bandwidth ranging from 3.2 to 3.43 GHz. It is the first time that a transmitarray unit cell, reconfigured employing liquid metal, provides a combination of low insertion loss and large phase shift range. The proposed prototype was fabricated and measured within an open‐ended waveguide and the measured results agree well with the simulations and verify the effectiveness of the design. The reconfigurable transmitarray unit cell can be used to design beam‐scanning arrays, as well as for applications in wireless communications.

Liquid–Metal Vertical Interconnects for Flip Chip Assembly of GaAs C-Band Power Amplifiers Onto Micro-Rectangular Coaxial Transmission Lines

A High-Efficiency K-band MMIC Linear Amplifier Using Diode Compensation

Through Si vias using liquid metal conductors for re-workable 3D electronics

Circuits and Antennas Incorporating Gallium-Based Liquid Metal

Low-loss liquid metal interconnects for superconducting quantum circuits

A reconfigurable transmitarray unit cell employing liquid metal

Low insertion loss interposer approach for RF applications based on commercial LTCC tape, alkaline-free glass and printed metallization

Low-Loss Single-Band, Dual-Band, and Broadband mm-Wave and (Sub-)THz Interconnects for THz SoP Heterogeneous System Integration

Liquid cooling in an LTCC-module for a switched mode amplifier

Thermal and Electrical Characterization of TSV Interposer Embedded with Microchannel for 2.5D Integration of GaN RF Devices

Liquid Metal Bandwidth-Reconfigurable Antenna

Liquid metal enabled microfluidics

Impact of microfluidic cooling on high power amplifier RF performance

Three-Dimensional Interconnection With Magnetically Coupled Transition for W-Band Integration Applications

A reconfigurable liquid metal antenna driven by electrochemically controlled capillarity

The Design and Manufacturing Process of an Electrolyte-Free Liquid Metal Frequency-Reconfigurable Antenna

3D‐Printed Multi‐scale Fluidics for Liquid Metals

Glass-on-Silicon Interposer with High Heat Dissipation Capacity and Excellent RF Compatibility

Design. Fabrication, and Test of an Embedded Si-Glass Microchannel Heat Sink for High-power RF Application

Gallium-Based Liquid Metal Amalgams: Transitional-State Metallic Mixtures (transm2ixes) with Enhanced and Tunable Electrical, Thermal, and Mechanical Properties