Abstract:This study investigates the correspondence between film cooling flow and convective heat transfer augmentation on the trailing edge cutback surface of a turbine blade, proposing a novel approach with oblong dimples in V-pattern pairs to enhance the cooling performance. Using transient infrared thermography coupled with the Impulse Response Method, detailed measurements of adiabatic film cooling effectiveness and heat transfer coefficients were obtained. Scale-Adaptive-Simulations (SAS) were also utilized to delve into the turbulent flow dynamics and elucidate the mechanisms behind the enhanced cooling performance. The experiments and simulations were conducted for a trailing edge model equipped with pin fin arrays inside the coolant channel and a land feature on the cutback surface. Overall, three different cutback surfaces were investigated: a smooth baseline geometry and two dimpled surfaces with different geometrical orientation. The cooling performance was evaluated over a range of blowing ratios spanning between 0.5 and 2. The results indicate that as the blowing ratio increases, there is a corresponding enhancement in both the adiabatic film cooling effectiveness and the heat transfer coefficients across all three cutback surface configurations. However, the dimpled patterns, when compared to the smooth one, showed a broader coolant film distribution and facilitated the formation of small-scale vortices, which in turn improved the heat transfer efficiency. Specifically, surfaces with a tighter arrangement of dimples exhibited superior cooling effects, achieving approximately 5.0 % increase in the film cooling effectiveness and an 8.9 % boost in the convective heat transfer coefficients. Moreover, the strategic placement of V-pattern dimples effectively steers the coolant flow close to the wall towards the land, significantly enhancing coolant spread and thus offering improved thermal protection for the land area. These findings hold the potential to significantly improve the performance of aero-engines by optimizing the trade-off between thermal management and aerodynamic efficiency of turbine blades.

Thermal-hydraulic performance investigation of the cooling passage featuring the ridged V-shaped dimple

Experimental Study on Forced Convection Hydraulic and Thermal Characteristics in a Dimpled Flat Duct

Thermo-hydraulic performance inside convergent rectangle channel with large-deformed dimples

Heat Transfer Analysis on Dimple Geometries and Arrangements in Dimple Jacketed Heat Exchanger

Numerical and Experimental Investigation of Flow and Heat Transfer in Heat Exchanger Channels with Different Dimples Geometries

The Structural Optimization of Dimple in Microchannel for Heat Transfer Enhancement

Evaluation of thermal hydraulic flow and enhancement of heat performance in different 3D dimpled tube configurations according to design of experiment analysis

Numerical investigation of flow and heat transfer in enhanced tube with slot dimples

Effect of dimple edge ratio on the thermo-aerodynamic performance in turbulent channel flow

Experimental and numerical study of heat transfer and friction factor characteristics of an inclined elliptical dimple channel having inline and staggered pattern

The thermo-aerodynamic performance of turbulent channel flow over dimples of different sizes

Flow friction and heat transfer characteristics evaluation for a rectangular channel with spherical dimples and protrusions

Effective heat transfer surfaces of tubes and plates with spiral vortex generators – inclined oval-trench dimples

Experimental Study of Heat Transfer and Pressure Loss in Channels with Miniature V Rib-Dimple Hybrid Structure

Effect of bleed position and bleed angle on impingement cooling of a spherical dimpled surface

Numerical investigation of air–steam condensation in a vertically enhanced tube with dimples and protrusions

Experimental Study on Flow Behavior and Heat Transfer Enhancement With Distinct Dimpled Gas Turbine Blade Internal Cooling Channel

Evaluation of thermal-hydraulic performance of dimpled tube from the perspective of skewness and kurtosis

Study the influence of concavity shapes on augmentation of heat‐transfer performance, pressure field, and fluid pattern in three‐dimensional pipe

Film cooling enhancement over oblong-dimpled cutback surfaces for the trailing edge of turbine blades

Heat Transfer and Flow Friction Characteristics of Dimple-Type Heat Exchanger in Axial Piston Pump