Abstract:The cost and endurance anxiety about proton exchange membrane fuel cells (PEMFCs) has prompted the rapid development of platinum-based (Pt-based) oxygen reduction electrocatalysts towards smaller particle sizes, higher durability and alloying. However, well-balanced these advanced trends by a simple approach is difficult in practice, because the existing solutions are problematic in removing the protective organic coating or oxide shell that preventing the high-temperature agglomeration of Pt-based nanocrystals, or broadening the size range of Pt-based nanocrystals which caused by the heterogeneous distribution of heteroatom anchor points on supports. With a self-developed strategy that based on the atomic layer deposition (ALD), we have addressed these problems in two aspects. One is directly loading size and distribution controllable Pt nanocrystals on diverse supports, and another is indirectly depositing easily removed ultra-thin metal oxide coating with dual functions on prefabricated ultrasmall Pt nanocrystals to restrain their sintering effect during high temperature ordering. By controlling the temperature and pulse time of ALD, we successfully synthesized ultrasmall (< 2 nm) Pt nanocrystals on surface inactive TiC nanoparticles and nanowires. These two new electrocatalysts exhibited comparable oxygen reduction activity and durability on par with commercial Pt/C with lower Pt loading. And using this strategy, about 1 nm ZnO coating on Pt nanocrystals was performed to construct uniform PtZn intermetallic nanocrystals with the ultrasmall size of 2.50 ± 0.65 nm and excellent stability for oxygen reduction reaction. The mass activity of PtZn intermetallic nanocrystals reaches to 0.60 A mgPt -1 at 0.9 V (6 times than commercial Pt/C) and only 13 mV decrease of half-wave potential after 30000 cycles of accelerated durability testing rivaling the most recently reported PtZn catalysts. Ultrasmall sizes and excellent features of our Pt and Pt-based intermetallic nanocrystals are all attributed to the accurate control of ALD and could be a promising method applying to other Pt-based intermetallic nanocrystals.

Single-atom Al precisely modulate the strain of Pt 3 Co intermetallic for superior oxygen catalytic performance

Local Coordination and Ordering Engineering to Design Efficient Core-Shell Oxygen Reduction Catalysts

Single atom surface engineering: A new strategy to boost electrochemical activities of Pt catalysts

Unveiling enhanced oxygen reduction activity in PtCo bimetallic solid solutions through controlled crystal strain

Thermally stable single atom Pt/m-Al2O3 for selective hydrogenation and CO oxidation

Oxygen Vacancy-Mediated Synthesis of Inter-Atomically Ordered Ultrafine Pt-Alloy Nanoparticles for Enhanced Fuel Cell Performance

Local tetragonal distortion of Pt alloy catalysts for enhanced oxygen reduction reaction efficiency

Ti Single Atom Enhancing Pt‐Based Intermetallics for Efficient and Durable Oxygen Reduction

Engineering the electronic and strained interface for high activity of PdMcore@Ptmonolayer electrocatalysts for oxygen reduction reaction

Strain Engineering to Enhance the Electrooxidation Performance of Atomic-Layer Pt on Intermetallic Pt3Ga.

L10‐PtCo and L12‐Pt3Co Intermetallics for Oxygen Reduction Reaction: the Influence of Composition and Structure on Properties

A Hydrothermally Stable Single-Atom Catalyst of Pt Supported on High-Entropy Oxide/Al 2 O 3 : Structural Optimization and Enhanced Catalytic Activity

Low-Pt Octahedral PtCuCo Nanoalloys: "One Stone, Four Birds" for Oxygen Reduction and Methanol Oxidation Reactions

Single-atom Mo-tailored high-entropy-alloy ultrathin nanosheets with intrinsic tensile strain enhance electrocatalysis

Engineering both intrinsic characteristic and local microenvironment of platinum sites toward highly efficient oxygen reduction reaction

Atomic-Level Construction of Tensile-Strained PdFe Alloy Surface toward Highly Efficient Oxygen Reduction Electrocatalysis

Hollow Porous Carbon-Confined Atomically Ordered PtCo 3 Intermetallics for an Efficient Oxygen Reduction Reaction

Tailored Lattice Compressive Strain of Pt‐skins by the L12‐Pt3M Intermetallic Core for Highly Efficient Oxygen Reduction

Activity Descriptor Identification for Oxygen Reduction on Platinum-Based Bimetallic Nanoparticles: In Situ Observation of the Linear Composition–Strain–Activity Relationship

(Digital Presentation) Controllable Preparation of Ultrasmall Pt-Based Intermetallic Nanocrystals Via Atomic Layer Deposition for Hydrogen Fuel Cell

Sub-4 nm PtCu3 intermetallic catalyst with L12-ordered structure toward efficient activity and durability for oxygen reduction