Abstract:Abstract The microwave cutoff probe (CP) is an accurate diagnostic technique to measure absolute electron density even in processing gas plasmas. Because this technique needs the installation of two probe tips and a probe body in the plasma chamber, it may cause plasma perturbation in semiconductor plasma processing; this may increase the uncertainty of the measured value. In this work, a flat CP, which is embedded in the substrate chuck or chamber wall, is proposed to measure electron density without plasma perturbation and to monitor processing plasma in real-time. We first evaluated the performance of various types of flat CPs, such as the point CP, ring CP, and bar cutoff probe (BCP), through electromagnetic (EM) field simulation. The BCP showed better performance with clearer cut-off signal characteristics and minimization of noise signals compared with the other probe types. Therefore, we focused on the characteristics of the BCP through experiments and/or EM simulations and concluded the followings: (i) the measured electron densities of the BCP agree well with those of the conventional CP; (ii) the BCP measures the plasma density near the plasma-sheath boundary layer, which is very closely adjacent to the chamber wall or wafer; (iii) it was demonstrated for the first time that the plasma density can be measured, even though the processing wafers such as un-doped silicon, P type silicon, amorphous carbon, or amorphous carbon/SiO 2 patterned wafers were placed on the flat CP; and (iv) we performed real-time measurements of the electron density using the BCP covered with the wafers in plasmas with various process gases, such as Ar, NF 3 , and O 2 . These results indicate that the chuck-embed-type or wall-type flat CP can be used as a real-time electron density measurement (monitoring) tool during industrial plasma processing, such as during etching, deposition, sputtering or implantation, and the chuck-embed-type flat CP can measure the plasma density impinging on the wafer in real-time without stopping the processing.

Development of a flat cutoff probe covered with a dielectric layer for non-invasive plasma diagnostics

Flat cutoff probe for real-time electron density measurement in industrial plasma processing

Analysis of Conductor Loss in Interdigital Capacitor Based Measurement of Dielectric Constant of Ferroelectric Thin Film

A Low Excitation Working Frequency Capacitively Coupled Contactless Conductivity Detection (C4D) Sensor for Microfluidic Devices

Attenuation Measurement of the Dielectric Rod Using Parallel Strips with a Resonable Field Environment

Real-time monitoring of the plasma density distribution in low-pressure plasmas using a flat-cutoff array sensor

Development of a Sensor for Dielectric Constant Measurements Utilizing Time-Domain Measurement with a Vector Network Analyzer

Theoretical and Experimental Study of the Microwave Cut-off Probe for Electron Density Measurements in Low-Temperature Plasmas

Contactless Measurement of Thin Film Conductivity by A Microwave Compact Equipment

Measurement of Dielectric Constant of Thin Film Materials at Microwave Frequencies

Optimization and application of the concentric conductance probes in liquid film thickness measurement in a helically coiled tube

Analysis of uncertainty in measurement of electron temperature in low-pressure inductively coupled plasmas using microwave cutoff probe

Experimental validity of double-curling probe method in film-depositing plasma

Noncontact dielectric constant metrology of low-k interconnect films using a near-field scanned microwave probe

Research on Plasma Electron Density Distribution Based on Microwave Diffraction

Design and Optimization of Microwave Sensor for the Non-Contact Measurement of Pure Dielectric Materials

Noncontact Thickness Measurement of Metal Films Using Eddy-Current Sensors Immune to Distance Variation

A Method for Sensing Dielectric Properties of Thin and Flexible Conductive Biocomposites

Pressure limitation of electron density measurement using a wave-cutoff method in weakly ionized plasmas

Measurement of In-Plane Thermal and Electrical Conductivities of Thin Film Using a Micro-Beam Sensor: A Feasibility Study Using Gold Film

Probe beam deflection technique with liquid immersion for fast mapping of thermal conductance