Effect of In2O3 Additive Size on the Mechanical Behavior of Densified Ag-SnO2 Contact Materials

Guijing Li,Xinlei Han,Danru Qi,Huanchong Lu,Wenjie Feng

DOI: https://doi.org/10.1007/s11665-024-09290-0

IF: 2.3

2024-03-02

Journal of Materials Engineering and Performance

Abstract:The nano and sub-micron In 2 O 3 powders were respectively used as additive to improve the mechanical properties of the densified Ag-SnO 2 contact materials. The compressive fracture mechanism was analyzed by microstructure characterization and numerical simulations. It was found that the size of the In 2 O 3 powders had obvious effect on the mechanical behavior of the Ag-SnO 2 materials. The materials with nano In 2 O 3 additive exhibited the excellent physical and mechanical properties. The optimal mass fraction of the nano In 2 O 3 additive in the materials was 1.0%. The electrical conductivity and relative density were increased to 77.0%IACS and 99.6%, respectively. Under the compressive loading, the initiation of the internal cracks led to the fracture of the Ag-SnO 2 contact material without additive. Notably, the nano In 2 O 3 additive effectively relieved the stress and strain concentrations inside the Ag-SnO 2 material, and the crack initiation was effectively suppressed, which was beneficial for improving compressive strength. However, it should be noted that the sub-micron In 2 O 3 additive about 400 nm inevitably induced the severe local strain and generated the cracks in Ag-SnO 2 material, resulting in the decrease of compressive strength. In addition, the layered microstructure was formed along the longitudinal section of the compressed Ag-SnO 2 material with nano In 2 O 3 additives due to the larger plastic deformation.

materials science, multidisciplinary