Abstract:While the interfacial phases between Al and high-entropy alloy (HEA) share the same types as that between Al and steel, it has been found previously that the thermal stability of the Al-HEA interfacial phases is significantly higher than that of the Al-steel interfacial phases. To further elucidate the reason for the exceptional thermal stability of Al-HEA interfacial phases, this study investigated the evolution of the interfacial phases formed between Al alloy and FeCoCrNiMn HEA during annealing. An Al-FeCoCrNiMn thin film diffusion couple was extracted from a friction stir lap welding (FSLW) joint by focused ion beam and then annealed at 400 degrees C. An amorphous layer is formed initially at the interface due to the high strain rate deformation during FSLW. The amorphous layer remained even after prolonged annealing at 400 degrees C (similar to 0.72 T-m of Al alloy) for 60 min with very limited thickening (from 50 nm to 55 nm), showing remarkable thermal stability at the relatively high temperature. Al13Fe4-type intermetallic compound (IMC) with the Fe site occupied by Fe, Co, Cr, Ni and Mn first nucleates at the interface between Al alloy and amorphous layer. With the annealing time extended to 180 min, the amorphous layer is partially transformed into Al5Fe2-type IMC. The rate constant for the thickening of the reaction layer at the Al/FeCoCrNiMn interface is 0.03 mu m center dot min(1/2), which is much smaller than (only 0.02 times) that at the Al/steel interface under similar annealing condition. The high thermal stability of Al-HEA interfacial layer is thus attributed to the slow kinetics in crystallization of the initially formed amorphous layer, the barrier effect of amorphous layer for interdiffusion, and the reduced diffusivity inside of IMCs caused by significant fluctuations in lattice potential energy due to high-density doping with HEA elements. This finding provides new insights into the fabrication of thermally stable Al-HEA hybrid structures suitable for service conditions involving high-temperature exposure.

Unexpected thermal stability of dual-phase amorphous-nanocrystalline Al0.74Mo0.26 alloy film prepared by annealing-induced crystallization

Exceptional thermal stability and mechanical properties of dual-phase amorphous-nanocrystalline Al–Mo alloy films

Synthesis, microstructure and properties of MoAlB MAB phase films

Crystallization behavior and corrosion resistance of Al86Ni10Zr4 amorphous alloy under different annealing treatment conditions

Introducing a new heterogeneous nanocomposite thin film with superior mechanical properties and thermal stability

Evolution of Interfacial Phases Between Al Alloy and High Entropy Alloy During Annealing

Different Alloying Behaviors of Co-Mo Multilayered Films Upon Ion Irradiation and Thermal Annealing

High Thermal Stability of Nanostructured Al Mediated by Heterophase Interfaces and Nanotwinning

The microstructural evolution of dual phase high entropy alloy thin films by annealing

New Insights of Solid-State Alloying and Amorphous-Nanocrystalline Cyclic Phase Transitions During Cr-40wt.%Mo Powder Milling

Thermal annealing on the soft magnetism, microwave properties, and magnetostriction in Co-Fe-C alloy films

Formation of an Intermetallic Phase by Crystallization in the Cr–Si–Ni–Al Amorphous Film

Extreme thermal stability in crystal-amorphous nanocrystalline CoCrFeMnNi high entropy alloy

The Crystallization of Cr–Si–Ni–Al Amorphous Films—nucleation and Growth of Intermetallic Phase Cr(Al,Si)2

Thermodynamic Characteristic and Phase Evolution in Immiscible Cr–Mo Binary Alloys

Stable Nanocrystalline NbMoTaW High Entropy Alloy Thin Films with Excellent Mechanical and Electrical Properties

Microstructural evolution and thermal stability in a nanocrystalline lightweight TiAlV0.5CrMo refractory high-entropy alloy synthesized by mechanical alloying

Influence of annealing on microstructures and mechanical properties of arc-deposited AlCrTiSiN coating

Symbiotically engineered crystalline-amorphous nanostructure in a strong-yet-stable Al alloy with large twinning-induced plasticity

Investigating the thermal stability of nanocrystalline aluminum-lithium alloy by combining different mechanisms: Reinforcing with graphene and alloying with Sr

On the remarkable thermal stability of nanocrystalline cobalt via alloying