Abstract:In tube–gusset plate connection (TGPC), the deformation stiffness of the stiffener plate is much greater than that of chord wall. The local instability and material failure in the stiffener plate are the primary failure modes of TGPC. In this article, an experimental, numerical and theoretical study on both the failure pattern and internal force distribution mechanism of the stiffener ring plates in the TGPC was carried out. An experimental study including the material tensile coupon tests and twelve TGPC tests was initially conducted, which detailedly presented the failure modes of the stiffener plates under either compression or tension. The failure of the stiffener plates was dominated by local instability when compression and was controlled by material failure when tension. Subsequently, a numerical investigation using finite element models (FEMs) of KT– and X–type joints was performed. The FEMs were validated against the present test results and those available in literature. Thereafter, in order to obtain the additional data of TGPC with multi–stiffener ring plates and verify the accuracy of the calculation model proposed below, the FEMs were then extended for a further investigation of the TGPCs containing three, four, and five ring stiffener plates with different gusset plate lengths. With considering the influence of the bending deformation in the plane of gusset plates on the distributed loads in stiffener ring plates, an elastic beam–spring bearing (EBSB) model was developed based on the conjugate beam theory. Finally, the numerical results were compared with those obtained using the Japanese code and EBSB model. It was seen that the influence of the bending deformation of the gusset plate on distributed loads in the stiffener ring plates became significant, and the proportion of the shear deformation of the gusset plate between the stiffeners to the total deformation was decreased, when the length of the gusset plate was increased. The distributed load in each stiffener ring plate predicted by the EBSB model was found to be more accurate than that obtained using the Japanese code. The proposed EBSB model can be used as the guidelines for the design of joints in actual transmission line engineering projects.

Numerical and theoretical analysis of staggered cruciform stubs

Tensile behavior of cruciform stubs with staggered bolt patterns

A Multi-Spring Component Modelling Approach for T-Stub Connections

Demand on Stiffeners in Stiffened Extended End-Plate Connections

FINITE ELEMENT ANALYSIS OF STIFFENED T-STUB CONNECTIONS

Experimental Study and Numerical Analysis of a Novel Serrated-and-plate Truss Structure

Experimental and numerical study on compressive behavior of welded hollow spherical joints with external stiffeners

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

Numerical investigations on large size stiffened angle connections with different bolt patterns

Effect of Stiffeners on Mechanical Behavior of T-Stubs Based on Experiment and Numerical Simulations

Numerical Analysis on Concrete-Filled Wide Rectangular Steel Tubular (CFWRST) Stub Columns under Axial Compression

Stub Column Tests of Thin-Walled Complex Section with Intermediate Stiffeners

Numerical Investigations on Elastic Buckling and Hysteretic Behavior of Steel Angles Assembled Buckling-Restrained Braces

Shear Resistance of Stiffened Steel Corrugated Shear Walls

Modeling of Steel Bolted T-Stub Connection under Large Deformation Condition

Finite element analysis on stamping car cradle with local thickening

Ultimate tensile behavior of bolted stiffened T-stub connections in progressive collapse resistance

Numerical study and design of S35657 stainless steel welded stub columns

Failure Pattern and Load Distribution Mechanism of Stiffeners in the Tube–gusset Plate Connection: Testing, Numerical Modelling and Theoretical Analysis

Test Analysis of Stiffened T-stub Connections

Numerical Investigation and Design Rules for Stress Concentration Factors of Stainless-Steel Hybrid Tubular Joints