Abstract:In the case of aluminium structures, welding may introduce weak zones, so-called heat-affected zones (HAZ), close to the weld. Such zones should be accounted for when predicting the overall behaviour of structures since the deformation tends to localise within such weak zones leading to the initiation of failure. Whereas the effect of welding on mechanical properties such as yield stress and work hardening is known, the ductility of a HAZ and how to model it in numerical simulations remain uncertain. To address this challenge, this article presents a combined experimental and numerical study on ductile fracture modelling of an aluminium alloy AA6063-T6 exposed to complex heat treatments. The first part includes preparation of specimens and uniaxial tension testing. A Gleeble machine is used to generate well-defined heat treatments involving high peak temperatures and heating rates. Subsequently, uniaxial tension tests at low and high strain rates are conducted. The results show the effect of the complex heat treatments on strength, strain-rate sensitivity, and fracture. The numerical part of this study concerns two widely used damage models, namely the Cockcroft-Latham fracture criterion and the Gurson-Tvergaard model. Calibration of material models and a parameter study are carried out based on analyses of the tension tests. To this end, a case study is conducted elaborating on the importance of the damage parameters within an idealised heat-affected zone and plane-strain tension. The main objective of this study is to obtain a more general understanding of ductile fracture modelling of aluminium alloys exposed to complex heat treatments representative of welding.

Numerical analysis of ductile fracture in stretch bending of AA6061-T6 aluminum alloy sheet using GTN damage model

Experimental and numerical investigation of failure during bending of AA6061 aluminum alloy sheet using the modified Mohr-Coulomb fracture criterion

Prediction of Fracture Behavior of 6061 Aluminum Alloy Based on GTN Model

Ductile fracture prediction in aluminium alloy 5A06 sheet forming based on GTN damage model

Characterization and prediction of fracture in 6000- and 7000-series aluminum alloy sheet under various stress states

Experimental-numerical analysis of ductile damage modeling of aluminum alloy using a hybrid approach: ductile fracture criteria and adaptive neural-fuzzy system (ANFIS)

Experimental and numerical investigations into the ductile fracture during the forming of flat-rolled 5083-O aluminum alloy sheet

Effect of stress triaxiality and normalized Lode angle on ductile fracture of aluminum 2139-T8

Forming Limit Prediction of Anisotropic Aluminum Magnesium Alloy Sheet AA5052-H32 Using Micromechanical Damage Model

Bending Limit Prediction of an Aluminum Thin Sheet

Influence of ductile damage on the bending behaviour of aluminium alloy thin sheets

Calibration procedures for a computational model of ductile fracture

Ductile fracture prediction of additive manufactured Ti6Al4V alloy based on an extended GTN damage model

Experimental and numerical study on the tensile ductility of an aluminium alloy with heat-affected zones

Modified Gtn Model for A Broad Range of Stress States and Application to Ductile Fracture

Modeling of the Ductile Fracture During the Sheet Forming of Aluminum Alloy Considering Non-Associated Constitutive Characteristic

Modeling of the ductile damage – Application for bar shearing

Experimental and numerical investigation on plasticity and fracture behaviors of aluminum alloy 6061-T6 extrusions

Prediction of failure in bending of an aluminium sheet alloy

Mechanism-Based Numerical Approach to Ductile Fracture in an 2024–T3 Aluminium Alloy

Material Parameters in the GTN Model for Ductile Fracture Simulation of G20Mn5QT Cast Steels