Abstract:Tunnels and foundation pits are two separate types of excavation that are frequently used in urban settings. Excavating tunnels and foundation pits sequentially around existing pile foundations is becoming more and more prevalent as urban underground space utilization rates increase. The deformation and load transfer mechanisms of the pile group foundation under two asymmetric excavation conditions of "first tunnel, then foundation pit" and "first foundation pit, then tunnel" are studied from the perspective of the relative positions of the tunnel-pile-foundation pit based on the constant gravity model test and 3D numerical simulation. The result shows: The pile settlement of the front pile (closer to the tunnel) caused by the excavation condition of the "first foundation pit-then tunnel" is relatively larger, while the pile settlement of the rear pile (closer to the foundation pit) caused by the excavation condition of "first tunnel-then pit" is larger. The transverse tilting of the pile group caused by the excavation of the "first foundation pit-then tunnel" is relatively larger. For the front pile, the pile tip resistance generated by "first excavation-then tunnel" is about 10% greater than it was before the initial excavation, which is greater than the result of "first tunnel-then foundation pit". For the rear pile, the pile tip resistance generated by "first excavation-then tunnel" is about 85% greater than it was before the initial excavation, which is smaller than the result of "first tunnel-then foundation pit". The multiple excavation sequence of "tunnel first-then foundation pit" leads to a larger induced bending moment for the front pile, whereas a larger induced bending moment for the rear pile results from the multiple excavation sequence "first foundation pit-then tunnel".

Numerical Optimization of Mini Centrifuge Modelling Test Design of Excavation Unloading Influence on Existing Tunnel Controlled by Partition Piles

Centrifuge Modeling of Monotonic and Cyclic Lateral Behavior of Monopiles in Sand

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Centrifuge model test on suction caisson foundation in soft clay subjected to lateral loads

Experimental and Numerical Investigation on the Effects of Foundation Pit Excavation on Adjacent Tunnels in Soft Soil

Dynami C Mul Ti-Obj Ecti V E Opti Mi Zati on Inv Er Se Pr Edi Cti on of Excavation-Induced Tunnel Displacement

Centrifugal Model Tests on Working Behavior of Composite Foundation Reinforced by Rigid Piles with Caps Under Embankment

Centrifuge Model Test Study on the Behavior of a Tunnel Under the Neighboring Excavation

Research on the Optimal Design of Retaining Piles of a Wide Metro Tunnel Foundation Pit Based on Deformation Control

Multi-Effects of Tunneling and Basement Excavation on Existing Pile Group

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Experimental and Theoretical Study for a Displacement-Controlled Design Method of Embedded Cantilever Retaining Walls (Piles)

Influence of Pile Foundation Construction on Existing Tunnels in a Metro Protection Area: Field Test and Numerical Simulation

Effects of deep excavation on uplift capacity of piles by centrifuge tests

Centrifuge modelling of tunnelling below existing twin tunnels with different types of support

Influence of Isolation Pile Diameter on Existing Metro Tunnel Displacement Caused by Excavation of Foundation Pit

Effects of Large-Scale Twin Tunnel Excavation on an Existing Pile Group: Three-Dimensional Centrifuge Modeling

Analysis of Position of Isolation Pile on Deformation of Existing Metro Tunnel Adjacent to Deep Excavation

In-Flight Simulation of the Excavation of Foundation Pit in Centrifuge Model Tests