Abstract:The effects of different modeling and solving approaches on the simulation of a steam ejector have been investigated with the computational fluid dynamics (CFD) technique. The four most frequently used and recommended turbulence models (standard k-ε, RNG k-ε, realizable k-ε and SST k-ω), two near-wall treatments (standard wall function and enhanced wall treatment), two solvers (pressure- and density-based solvers) and two spatial discretization schemes ( the second-order upwind scheme and the quadratic upstream interpolation for convective kinematics (QUICK) of the convection term have been tested and compared for a supersonic steam ejector under the same conditions as experimental data. In total, more than 185 cases of 17 different modeling and solving approaches have been carried out in this work. The simulation results from the pressure-based solver (PBS) are slightly closer to the experimental data than those from the density-based solver (DBS) and are thus utilized in the subsequent simulations. When a high-density mesh with y+ < 1 is used, the SST k-ω model can obtain the best predictions of the maximum entrainment ratio (ER) and an adequate prediction of the critical back pressure (CBP), while the realizable k-ε model with the enhanced wall treatment can obtain the best prediction of the CBP and an adequate prediction of the ER. When the standard wall function is used with the three k-ε models, the realizable k-ε model can obtain the best predictions of the maximum ER, and the three k-ε models can gain the same CBP value. For a steam ejector with recirculation inside the diffuser, the realizable k-ε model or the enhanced wall treatment is recommended for adoption in the modeling approach. When the spatial discretization scheme of the convection term changes from a second-order upwind scheme to a QUICK scheme, the effect can be ignored for the maximum ER calculation, while only the CBP value from the standard k-ε model with the standard wall function is reduced by 2.13%. The calculation deviation of the ER between the two schemes increases with the back pressure at the unchoked flow region, especially when the standard k-ε model is adopted. The realizable k-ε model with the two wall treatments and the SST k-ω model is recommended, while the standard k-ε is more sensitive to the near-wall treatment and the spatial discretization scheme and is not recommended for an ejector simulation.

A physics-based hybrid model for supercritical CO2 ejector in critical flow regime

A Comparative Study on Regulation Methods for Transcritical CO2 Ejector Expansion Refrigeration System.

Ejector Used in Transcritical CO_2 Heat Pump System

Modelling, Optimization, and Experimental Studies of Refrigeration CO2 Ejectors: A Review

Dynamic Simulation on Operating Modes of Ejector in Transcritical Co2 Ejector Expansion Refrigeration Cycles

Two-phase Simulation of Transcritical CO _2 Flow in Nozzle and Ejector Using the Homogeneous Equilibrium Model

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

Theoretical model of transcritical CO 2 ejector with non-equilibrium phase change correlation

An extended mechanism model of gaseous ejectors

Flow Visualization of Supersonic Two-Phase Transcritical Flow of CO2 in an Ejector of a Refrigeration System

Research on Co2 Ejector Component Efficiencies by Experiment Measurement and Distributed-Parameter Modeling

Assessment of Different CFD Modeling and Solving Approaches for a Supersonic Steam Ejector Simulation

Energy and Exergy Analysis of an Ejector Expansion Transcritical Carbon Dioxide Air Conditioning System

Numerical investigation in effects of refrigerants' thermodynamic properties on performance of supersonic ejector

Transient numerical study of CO 2 two-phase flow in a needle adjustable ejector

An experimental and theoretical study of a CO2 ejector

Development of Control Model for Critical Operation Ejector

A full operating conditions ejector model for refrigeration systems driven by low-grade heat sources

Numerical Investigation on the Performance of Transcritical CO2 Two-Phase Ejector with a Novel Non-Equilibrium CFD Model

Dynamic Simulation Study on Regulation Characteristics of Transcritical CO2 Multi-Ejector Refrigeration System

Performance of Transcritical Carbon Dioxide System with Ejector