Abstract:Although oceans play a key role in the global selenium (Se) cycle, there is currently very little quantitative information available on the distribution of Se concentrations and Se speciation in marine environments. In general, determining Se concentration and speciation in seawater is highly challenging due to very low Se levels ((sub)ng⋅L-1), whereas matrix elements interfering Se pre-concentration and detection are up to the g⋅L-1 levels. In this study, we established a sensitive method for the determination of the various Se chemical fractions present in natural seawater, i.e. selenite (SeIV), selenate (SeVI), organic Se-II + Se0 and total Se, using species-specific isotope dilution gas chromatography coupled to inductively coupled plasma mass spectrometry (ID-GC-ICP-MS). We compared different derivatization reagents and optimized specific pre-treatment protocols, including a microwave assisted oxidation protocol for the determination of total Se and organic Se-II + Se0 using H2O2. To increase sensitivity, we developed an online pre-concentration method based on large volume injection (LVI) using a programmed temperature vaporization (PTV) inlet. Eventually, the developed method achieved low absolute and methodological detection limits, i.e., respectively, 0.1-0.3 pg and 0.9-3.1 ng.L-1 for the different fractions. The accuracy of our method was of 2% for a certified reference material (CRM) diluted in artificial seawater while the precision was better than 4% for a freshwater CRM in artificial seawater matrix as well as two common seawater CRMs certified for trace elements excluding Se. As a proof-of-concept, we quantified the various Se fractions in a large number of natural water samples from the Baltic and North Seas, encompassing a wide range of salinity (7-35 psu), which shows that its detection limits are sufficient to determine total Se, SeIV, SeVI and organic Se-II + Se0 concentrations in brackish and marine systems.

Coprecipitation as a One-Step Se Separation for Determination of Isotope Ratios Completed with Revised Uncertainty Evaluation

Novel Approach for the Accurate Determination of Se Isotope Ratio by Multicollector ICP-MS

Precise Selenium Isotope Measurement in Seawater by Carbon-Containing Hydride Generation-Desolvation-mc-icp-ms after Thiol Resin Preconcentration

Stability of selenium and its speciation analysis in water using automatic system separation and HR-ICP-MS measurement

High Precision Isotope Ratio Measurements of Mercury Isotopes in Cinnabar Ores Using Multi-Collector Inductively Coupled Plasma Mass Spectrometry

Trace determination of selenium in biological samples by CH4-Ar mixed gas plasma DRC-ICP-MS

Acidification-Separation of Matrix and Determinationof Impurities in High Purity Selenium by ICP-MS

Determination of Platinum‐Group Elements and Re‐Os Isotopes Using ID‐ICP‐MS and N‐TIMS from a Single Digestion after Two‐Stage Column Separation

Determination of Inorganic Selenium Speciation in Natural Water by Sector Field Inductively Coupled Plasma Mass Spectrometry Combined with Hydride Generation

Sensitive analysis of selenium speciation in natural seawater by isotope-dilution and large volume injection using PTV-GC-ICP-MS

Simultaneous Speciation of Inorganic Selenium and Antimony in Water Samples by Electrothermal Vaporization Inductively Coupled Plasma Mass Spectrometry Following Selective Cloud Point Extraction

On-line Organoselenium Interference Removal for Inorganic Selenium Species by Flow Injection Coprecipitation Preconcentration Coupled with Hydride Generation Atomic Fluorescence Spectrometry.

Rapid determination of ¹³⁵Cs and precise ¹³⁵Cs/¹³⁷Cs atomic ratio in environmental samples by single-column chromatography coupled to triple-quadrupole inductively coupled plasma-mass spectrometry.

Simultaneous Determination of Trace Amounts of As, Se and Hg in Biological Samples by HG-ICP-MS

Alkaline fusion-alkaline mode HG-ICP spectrometry for selenium determination

High Precision Determination of Mercury Isotope Ratios Using Online Mercury Vapor Generation System Coupled with Multicollector Inductively Coupled Plasma-Mass Spectrometer

Determination Of Ultra-Trace Amounts Of Selenium In Environmental Samples By Sequential Injection-Hydride Generation-Nondispersive Atomic Fluorescence Spectrometry

Direct separation of Zn from dilute aqueous solutions for isotope composition determination using multi-collector ICP-MS

Coprecipitation of Mercury from Natural Iodine-Containing Seawater for Accurate Isotope Measurement

Ultrasensitive Determination of Selenium by Atomic Fluorescence Spectrometry Using Nano-Tio2 Pre-Concentration and in Situ Hydride Generation

Determination of Trace Amounts of Se(IV) by Hydride Generation Atomic Fluorescence Spectrometry after Solid-Phase Extraction Using Magnetic Multi-Walled Carbon Nanotubes.