Abstract:Mercury is a toxic element that can have negative effects on the environment and human health. The study of its isotopic composition provides essential information on the origin and distribution of Hg species in the environment. The determination of precise and accurate Hg species-specific isotope ratios can be carried out by coupling chromatographic techniques with multicollector ICP-MS. The preferential transmission of heavier versus lighter isotopes at the ICP-MS interface influences the isotope ratio calculation. This so-called mass bias effect must be corrected to obtain accurate and precise Hg isotope ratios. When dealing with transient signals, such as those obtained from the coupling of gas chromatography with MC-ICP-MS, mass bias has a higher impact on isotope ratio accuracy and precision than when working with continuous signals. Accuracy and precision of compound-specific isotope ratios can be improved by calculating isotope ratios from the slope of a linear regression between two isotopic signals. However, mass bias correction using this strategy needs a careful evaluation that has not been reported thus far. We demonstrate here that the classical mass bias correction based on a point-by-point isotope ratio calculation does not correct for variations of the Tl isotope ratio during Hg elution. Better internal precision in the Hg( II )-specific isotope ratios was obtained applying the mass bias correction models of Russell and Baxter and the linear regression approach for Tl isotope ratios. However, a large range of data points for Tl isotope ratios along the chromatographic peak profile must be selected to improve the internal accuracy of the Hg( II )-specific isotope ratio measurements. The standard-sample bracketing and Baxter approaches combined with the Russell and Baxter models were tested for the calculation of Hg( II )-specific delta values and did not show significant differences in terms of accuracy and precision which were evaluated with the analysis of NIST 3133 vs. NIST 3133 and NIST 8610 vs. NIST 3133, respectively.

High Precision Determination of Mercury Isotope Ratios Using Online Mercury Vapor Generation System Coupled with Multicollector Inductively Coupled Plasma-Mass Spectrometer

High Precision Isotope Ratio Measurements of Mercury Isotopes in Cinnabar Ores Using Multi-Collector Inductively Coupled Plasma Mass Spectrometry

High Precision Hg Isotope Analysis of Environmental Samples Using Gold Trap-Mc-Icp-Ms

A novel application of an isotope binary mixing model for determination of precise mercury isotopic composition in samples with low mercury concentration.

Determination of Trace Mercury Isotopes in Liquid and Solid Samples by Inductively Coupled Plasma Mass Spectrometry with Oxidation , Purge-Trap , Dual-Stage Thermal Desorption.

Online anion exchange column preconcentration and high performance liquid chromatographic separation with inductively coupled plasma mass spectrometry detection for mercury speciation analysis.

Extending the application range of Hg isotopic analysis to sub-μg L−1 levels using cold vapor generation multi-collector inductively coupled plasma-mass spectrometry with 1013 ohm Faraday cup amplifiers

Interfacing Nanoliter Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry with an In-Column High-Pressure Nebulizer for Mercury Speciation.

Determination of Mercurial Species in Fish by Inductively Coupled Plasma Mass Spectrometry with Anion Exchange Chromatographic Separation

An improved dual-stage protocol to pre-concentrate mercury from airborne particles for precise isotopic measurement

Development and optimization of a triple quadrupole ICP-MS–based system for the quantification of pre-concentrated gaseous elementary mercury

Development and initial evaluation of a combustion-based sample introduction system for direct isotopic analysis of mercury in solid samples via multi-collector ICP-mass spectrometry

Determination of the Isotopic Composition of Aqueous Mercury in a Paddy Ecosystem Using Diffusive Gradients in Thin Films.

Mercury isotope fractionation during volatilization of Hg(0) from solution into the gas phase

Optimized ultrasound-assisted dispersive liquid–liquid microextraction for simultaneous trace multielement determination of heavy metals in environmental water samples by ICP-MS

Speciation analysis of mercury by liquid chromatography coupled with on-line sorbent extraction preconcentration and cold vapour atomic absorption spectrometry

Studies on the Determination of Mercury by On-line Solvent Extraction and Non-Aqueous Media Hydride Generation Non-Dispersive Atomic Fluorescence Spectrometry

Chromatographic Pre-Concentration of Hg from Dilute Aqueous Solutions for Isotopic Measurement by Mc-Icp-Ms

Comparison of different mass bias correction procedures for the measurement of mercury species-specific isotopic composition by gas chromatography coupled to multicollector ICP-MS

Rapid Determination of Hg Isotopes in Low Concentration Water Samples by Flow Injection-Plasma Electrochemical Vapor Generation

Determination of Total Mercury in Biological Tissue by Isotope Dilution ICPMS after UV Photochemical Vapor Generation.