Abstract:Recent experimental studies of molten metal droplets wetting high temperature reactive substrates have established that the majority of triple-line motion occurs when inertial effects are dominant. In light of these studies, this paper investigates wetting and spreading on reactive substrates when inertial effects are dominant using a thermodynamically derived, diffuse interface model of a binary, three-phase material. The liquid-vapor transition is modeled using a van der Waals diffuse interface approach, while the solid-fluid transition is modeled using a phase field approach. The results from the simulations demonstrate an $O \left( t^{-\nicefrac{1}{2}} \right)$ spreading rate during the inertial regime and oscillations in the triple-line position when the metal droplet transitions from inertial to diffusive spreading. It is found that the spreading extent is reduced by enhancing dissolution by manipulating the initial liquid composition. The results from the model exhibit good qualitative and quantitative agreement with a number of recent experimental studies of high-temperature droplet spreading, particularly experiments of copper droplets spreading on silicon substrates. Analysis of the numerical data from the model suggests that the extent and rate of spreading is regulated by the spreading coefficient calculated from a force balance based on a plausible definition of the instantaneous interface energies. A number of contemporary publications have discussed the likely dissipation mechanism in spreading droplets. Thus, we examine the dissipation mechanism using the entropy-production field and determine that dissipation primarily occurs in the locality of the triple-line region during the inertial stage, but extends along the solid-liquid interface region during the diffusive stage.

Effect of substrate temperature on the deformation of liquid metal droplets during spreading and solidification

Solidification process of hollow metal droplets impacting a substrate

Influence of Temperature-Dependent Physical Properties on Liquid Metal Droplet Impact Dynamics

Role of melting and solidification in the spreading of an impacting water drop

A Numerical Analysis on the Metal Droplets Impacting and Spreading out on the Substrate

Solidification of liquid metal droplet during impact in the presence of vertical magnetic field

Rapid droplet spreading on a hot substrate

Numerical Investigation of Substrate Melting and Deformation During Thermal Spray Coating by SPH Method

Wetting and Spreading Characteristics of the Impact of Molten Aluminum Droplets on Surfaces

Studies of splat morphology and rapid solidification during thermal spraying

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Effect of Droplet Initial Temperature on Substrate Melting and Its Re-solidification in Plasma Spray Process

Impact dynamics and solidification behaviour of a molten droplet on a flat surface at different Weber numbers

A Study on the Impact of Liquid Metal Droplets Onto Metal and Elastomer Substrates

Modeling Reactive Wetting when Inertial Effects are Dominant

Analytical Consideration For The Maximum Spreading Factor Of Liquid Droplet Impact On A Smooth Solid Surface

Wettability and Interfacial Heat Transfer During Solidification of Al–Si Alloy (A413) Melt Droplets on Metallic Substrates

Investigation of the spreading of a liquid metal droplet under a vertical magnetic field

Investigation on the spreading and solidification of supercooled gallium droplets during impact

Three-dimensional numerical simulation on the spreading characteristics of a liquid metal droplet in a horizontal magnetic field