Abstract:In a zero-voltage switching (ZVS) inverter, high conversion efficiency and miniaturization are expected since switching loss can be dramatically reduced with proper design. In order to realize ZVS condition, auxiliary components such as inductors, capacitors, and switches are embedded in the inverter to implement the function. Since the design of auxiliary components is critical to the ZVS inverter, it is impossible to realize maximum efficiency or minimum size by following the conventional design procedure. This paper introduces an optimized design methodology for a three-phase ZVS inverter with objectives of both high efficiency and miniaturization. Based on the loss models of different commercial IGBT modules under different ZVS conditions, as well as the loss models of auxiliary components and filter inductors, the issue of pursuing highest efficiency and power density is transformed into solving a constrained nonlinear multivariable problem. According to the proposed design methodology, all parameters that influence the efficiency and physical dimensions are considered simultaneously. Thus, the optimized selection of the IGBT module, the parameters of the auxiliary components and the filter inductors would be obtained. A 30-kW three-phase ZVS inverter prototype is built to verify the proposed design method. With proposed design method, the improved prototype has achieved both smaller passive components volume and higher efficiency compared to the former prototype.

Dynamic Gate Delay Time Control of Si/SiC Hybrid Switch for Loss Minimization in Voltage Source Inverter

Adaptive Gate Delay-Time Control of Si/SiC Hybrid Switch for Efficiency Improvement in Inverters

100Kw Soft Switching Three-Phase Inverter with Hybrid Switches

Operation and Modulation of H7 Current Source Inverter with Hybrid SiC and Si Semiconductor Switches

Optimization of Turn-on Loss Reduction and Analytical Model of SiSiC Hybrid Switch

Modeling and Optimization of a Zero-Voltage Switching Inverter for High Efficiency and Miniaturization

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

Power Loss Model and Device Sizing Optimization of Si/SiC Hybrid Switches

Performance Comparison of Two Hybrid Si/SiC Device Concepts

A Variable-Frequency Current-Dependent Switching Strategy to Improve Tradeoff Between Efficiency and SiC MOSFET Overcurrent Stress in Si/SiC-Hybrid-Switch-Based Inverters

SiC Full-Bridge Grid-Tied Inverter with ZVS-switching

Comprehensive optimization of ZVS variable frequency control for SiC/Si HANPC Converter

Efficiency Improvement of Grid Inverters With Hybrid Devices

Optimization of Power Sharing and Switching Frequency in Si/WBG Hybrid Half-Bridge Converters using Power Loss Models

Efficiency improvement of a SiC-MOSFET 500 kHz ZVS inverter

A 1200 V/200 A Half-Bridge Power Module Based on Si IGBT/SiC MOSFET Hybrid Switch

A voltage controlled current source gate drive method for IGBT devices

An Optimized Switching Strategy Based on Gate Drivers with Variable Voltage to Improve the Switching Performance of SiC MOSFET Modules

A Hybrid Active Gate Drive for Switching Loss Reduction and Voltage Balancing of Series-Connected IGBTs

An Active Gate Driver Design to Reduce Voltage and Current Overshoots for SiC MOSFET Modules

A New Control Strategy for Converters Based on Hybrid Switch