Abstract:The higher voltage blocking capability and faster switching speed of silicon-carbide (SiC) mosfets have the potential to replace Si insulated gate bipolar transistors (IGBTs) in medium-low-voltage and high-power applications. In this paper, a state-of-the-art commercially available 325 A, 1700 V SiC mosfet module has been fully characterized under various load currents, bus voltages, and gate resistors to reveal their switching capability. Meanwhile, Si IGBT modules with similar power ratings are also tested under the same conditions. From the test results, several interesting points have been obtained: different to the Si IGBT module, the over-shoot current of the SiC mosfet module increases linearly with the increase of the load current and it has been explained by a model of the over-shoot current proposed in this paper; the induced negative gate voltage due to the complementary device turn-off (crosstalk effect) is more harmful to the SiC mosfet module than the induced positive gate voltage during turn-on when the gate off-voltage is 6 V; the maximum dvdt and didt (electromagnetic interference) during switching transients of the SiC mosfet module are close to those of the Si IGBT module when the gate resistance is larger than 8 but the switching loss of the SiC mosfet module is much smaller; the switching losses of the Si IGBT module are greater than those of the SiC mosfet module even when the gate resistance of the former is reduced to zero. An accurate power loss model, which is suitable for a three-phase two-level converter based on SiC mosfet modules considering the power loss of the parasitic capacitance, has been presented and verified in this paper. From the model, a 96.2 efficiency can be achieved at the switching frequency of 80kHz and the power of 100 kW.

A 1200 V/200 A Half-Bridge Power Module Based on Si IGBT/SiC MOSFET Hybrid Switch

100Kw Soft Switching Three-Phase Inverter with Hybrid Switches

Hybrid SiC-Si DC–AC Topology: SHEPWM Si-IGBT Master Unit Handling High Power Integrated with Partial-Power SiC-MOSFET Slave Unit Improving Performance

Design of Low Parasitic Inductance SiC MOSFETs Halfbridge Power Modules

Operation and Modulation of H7 Current Source Inverter with Hybrid SiC and Si Semiconductor Switches

ZVS range extension of 10A 15kV SiC MOSFET based 20kW Dual Active Half Bridge (DHB) DC-DC converter

Practical Design Considerations for a Si IGBT + SiC MOSFET Hybrid Switch: Parasitic Interconnect Influences, Cost, and Current Ratio Optimization

An SiC MOSFET & Si Diode Hybrid Three-Phase High-Power Three-level Rectifier

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

Fabrication and Dynamic Switching Characteristics of 6.5kv400a SiC MOSFET Module

A Quasi-Two-Level Medium-Voltage SiC MOSFET Power Module with Low Loss and Voltage Self-Balance

1700 V full-SiC half-bridge power module with low switching loss

High Temperature Direct Double Side Cooled Inverter Module for Hybrid Electric Vehicle Application

Three-Terminal Si/SiC Hybrid Switch

Performance Evaluation of High-Power SiC MOSFET Modules in Comparison to Si IGBT Modules

Characteristics of a 1200 V Hybrid Power Switch Comprising a Si IGBT and a SiC MOSFET

An Indirect Series-Connected SiC MOSFET Power Module with Voltage Self-Balance

Efficiency Improvement of Grid Inverters With Hybrid Devices

Development of 6kv SiC Hybrid Power Switch Based on 1200V SiC JFET and MOSFET

3.38 Mhz Operation of 1.2kv SiC MOSFET with Integrated Ultra-Fast Gate Drive