Construction of Dynamic Recrystallization Critical Strain Model, Kinetic Model, and Hot Workability of Mg–8Gd–4Sm–1Zn–0.5Zr Alloy

Xikuan Guo,Jun Chen,Quanan Li,Xiaoya Chen,Limin Zhu,Zhen Zhang
DOI: https://doi.org/10.1002/adem.202401127
IF: 3.6
2024-10-19
Advanced Engineering Materials
Abstract:The dynamic recrystallization (DRX) behavior and hot workability of Mg–8Gd–4Sm–1Zn–0.5Zr alloy are investigated by hot compression experiments. The critical strain model, DRX kinetic model and the processing maps are constructed by the stress–strain curves. According to the processing maps and evolution of the microstructure of the alloy at different strain conditions, the mechanisms of instability regions are studied, and the most suitable regions for hot working are identified. The dynamic recrystallization (DRX) behavior and hot workability of Mg–8Gd–4Sm–1Zn–0.5Zr alloys are investigated by the Gleeble‐1500 test machine. The tests are performed at 350–470 °C with a strain rate of 0.002–1 s−1. The results show that the stress–strain curves exhibit a typical single‐peak DRX behavior. The DRX critical strain model of the alloy is constructed according to the inflection characteristics of the work hardening rate curve. The DRX kinetic model is constructed according to Avrami equation. The 3D processing maps are obtained based on the dynamic material model. The mechanisms of instability regions are investigated by combining the processing map and the microstructural evolution, and the most suitable regions for hot working are identified. The critical strain εc of the alloy is reduced at higher deformation temperatures or lower strain rates, and the DRX more easily occurs. That is, the material is more suitable for hot working. The optimum domain for hot working of Mg–8Gd–4Sm–1Zn–0.5Zr alloy is the temperature range of 400–470 °C and strain rate range of 0.002–0.05 s−1.
materials science, multidisciplinary
What problem does this paper attempt to address?