Abstract:An anion exchange membrane (AEM) with good ion conductivity and high durability is greatly needed in the area of electrochemical energy conversion and storage systems. An AEM with a phase separation morphology has been shown to be an efficient strategy. Here, we randomly tethered a fluorocarbon segment and a tri-quaternary ammonium side chain to the poly(phenylene oxide) (PPO) backbone (PPO-22-3QA8F), aiming to increase the thermodynamic immiscibility between the hydrophobic/hydrophilic units and thereby produce an AEM with better phase separation but suppressed water uptake. With the premise of similar ion contents, two AEMs tethered with tri-quaternary ammonium (PPO-8-3QA) and benzyltrimethylammonium (PPO-22-QA) were synthesized for comparison. Incorporating an additional hydrophobic side chain turned out to be an effective way to drive the membrane's phase separation and the formation of well-connected ion conducting channels. PPO-22-3QA8F exhibited the highest hydroxide conductivity among the three AEMs up to 83 mS cm-1 in Milli-Q water at 90 degrees C, which is over 2 times higher than that of PPO-8-3QA (39 mS cm-1) and PPO-22-QA (27 mS cm-1). In addition, PPO-223QA8F exhibited a reasonable water uptake of less than 20 wt% at room temperature and excellent alkaline stability in 1 M NaOH at 80 degrees C for 7 days. As the immersion time was extended to 21 days, the PPO-223QA8F membrane was ductile and retained 51% of its original conductivity, while the other two controls were broken to pieces. A H2/O2 fuel cell prototype was evaluated using the PPO-22-3QA8F membrane as a separator to achieve a peak power density of 102 mW cm-2, which was nearly 3 times higher than that of the PPO-8-3QA membrane (38 mW cm-2) under the same operating conditions. Overall, the results of this study provide an efficient strategy to guide the architectural design of high-performance AEMs.

Helical Configuration Channels Boost Performance in Anion Exchange Membranes

Boosting the performance of an anion exchange membrane by the formation of well-connected ion conducting channels

Hydrophilic Side Chain Assisting Continuous Ion-Conducting Channels for Anion Exchange Membranes

Anion Conductive Membrane Performance Facilitation Via Tethering Flexible with Rigid Backbones Using Oscillational Chain

Highly Ion-Conductive and Alkaline Stable Anion Exchange Membranes Containing Bulky Aryl Units and Symmetric Bis-Piperidinium Branches

Dual Hydrophobic Modifications Toward Anion Exchange Membranes with Both High Ion Conductivity and Excellent Dimensional Stability

Engineering of Interconnected Ionic Channels in Polybenzimidazole Anion-Exchange Membranes

High Performance Anion Exchange Membranes with Confined Sub‐2‐nm Ion Channel

Construction of Ion Conducting Channels by Embedding Hydrophilic Oligomers in Piperidine Functionalized Poly(2, 6-Dimethyl-1, 4-Phenylene Oxide) Membranes

Highly Conductive Anion Exchange Membranes with Long Flexible Multication Spacer

Anion Exchange Membranes Based on Poly(aryl Piperidinium) Containing Both Hydrophilic and Hydrophobic Side Chains

High-performance Anion Exchange Membranes Based on Poly(aryl Piperidinium): with Interpenetrating Ion Transport Channels Induced by Fluorinated Crosslinking and Side Chains

Rational Design Protocols to Tune the Morphology and Conductivity of Poly (arylene Alkylene)-Based Anion Exchange Membranes

Tuning Polar Discrimination Between Side Chains to Improve the Performance of Anion Exchange Membranes

Improvement the hydroxide conductivity and alkaline stability simultaneously of anion exchange membranes by changing quaternary ammonium and imidazole contents

Highly Charged Hierarchically Structured Porous Anion Exchange Membranes with Excellent Performance

Diamine Crossklinked Anion Exchange Membranes Based on Poly(vinyl Benzyl Methylpyrrolidinium)

Click Chemistry Finds Its Way in Constructing an Ionic Highway in Anion-Exchange Membrane

Improving the Conductivity and Dimensional Stability of Anion Exchange Membranes by Grafting of Quaternized Dendrons

Construction of Reliable Ion-Conducting Channels Based on the Perfluorinated Anion-Exchange Membrane for High-Performance Pure-Water-fed Electrolysis

Self-Assembly of Porphyrin to Realize the High Ionic Conductivity of Anion-Exchange Membranes