Abstract:Different from the widely used high-voltage (HV) inductive power transfer (IPT) systems, the low-voltage IPT systems with HV input suffer from the following challenges: the high output current brings high conduction losses in the secondary side, especially at the receiver coil; and the HV conversion ratio, such as 400 V input and 24 V output, results in the difficulties in designing the compensation parameters and loosely coupled transformer. To overcome these issues, a novel IPT topology is proposed in this article by incorporating the series-capacitor full-bridge (SCFB) inverter and inverse coupled current doubler rectifier. Thus, the following three improvements are achieved: first, the voltage stress of three primary switches is reduced to half of the input voltage because of the special series capacitor structure. Second, the inherent one-fourth voltage conversion ratio is achieved and reduced greatly the difficulties in designing the compensation parameters. Third, the current flowing through rectifier circuit is reduced to half of conventional full-bridge rectifier. Furthermore, the LC-LCC compensation is employed for matching the proposed SCFB topology while a novel parameter optimization method is proposed to improve the conversion efficiency. To demonstrate the claimed features of the proposed solution, a 1.2 kW IPT prototype with 400 V input, constant voltage 24 V output is built and tested. The measured efficiency curve indicates that the efficiency from 8 to 50 A load keeps above 94.5% and peaks at 96.63%.

High-Efficiency Bilateral S–SP Compensated Multiload IPT System With Constant-Voltage Outputs

A Hybrid IPT System Implementing Misalignment Tolerance and Constant Current Output with Primary Intermediate Coil

Multiple Coils IPT System Implementing CV Output Characteristics with Improved Misalignment Tolerance

Design of an Inductive Power Transfer System with Constant Current and Constant Voltage Outputs Based on Multi-frequency Circuit

A Hybrid IPT System with High-Misalignment Tolerance and Inherent CC–CV Output Characteristics for EVs Charging Applications

A Gyrator-Based Converting-Splitting Method of Designing Inductive Power Transfer Systems with Constant Current and Constant Voltage Charging

Analysis and Design of an IPT System Based on Shunt Inductor Compensation for Battery Charging Applications.

A Domino-Type Load-Independent Inductive Power Transfer System With Hybrid Constant-Current and Constant-Voltage Outputs

A High-Efficiency IPT System With Series-Capacitor Full-Bridge Configuration and Inverse Coupled Current Doubler Rectifier for High-Input, Low-Voltage, and High Output Current Applications

Minimizing Current in Inductive Power Transfer Systems With an Asymmetrical Factor for Misalignment Tolerance and Wide Load Range

Balanced Design Method for LCL/LCL Compensation Achieving Wide Load Range and High Misalignment Tolerance

An Inductive Power Transfer System Design with Large Misalignment Tolerance for EV Charging.

An Integrated Inductive Power Transfer System Design with a Variable Inductor for Misalignment Tolerance and Battery Charging Applications

A Series-Parallel Compensated IPT System with Load-Independent Voltage Gain and Efficiency

Compact Capacitive Compensation for Adjustable Load-Independent Output and Zero-Phase-Angle Input for High Efficiency IPT Systems

An Improved LCC-S Compensated Inductive Power Transfer System with Wide Output Voltage Range and Unity Power Factor

Novel IPT system for enhanced efficiency and anti-misalignment capability

An IPT System with Constant Current and Constant Voltage Output Features for EV Charging

Analysis and Design of an IPT System Based on S/SP Compensation with Improved Output Voltage Regulation.

Design of Constant-Voltage and Constant-Current Output Modes of Double-Sided LCC Inductive Power Transfer System for Variable Coupling Conditions