Abstract:This paper presents a level-crossing successive-approximation-register (LC-SAR) hybrid analog-to-digital converter (ADC) that combines an LC ADC with an SAR ADC, which may be used for Internet of Things (IoT) random sparse event scenarios. The sampling frequency of a traditional LC ADC is usually proportional to the maximum instantaneous rate of change of the input signal; therefore, a higher input signal frequency inevitably leads to higher system power consumption. However, the proposed hybrid ADC uses the input level difference between the two moments before and after level-crossing detection, thereby ensuring a higher conversion precision and lower power consumption, even at higher input signal frequencies. Compared with traditional LC ADC or SAR ADC, the proposed hybrid ADC combines the ultralow-power advantage of LC ADC with the high-precision advantage of SAR ADC in converting IoT data with sparse characteristics such as ECG, EEG, and brain potential. The LC-SAR hybrid ADC is designed with a 0.18 μm CMOS process and consumes 4.34 μW at a 1.8 V supply voltage, achieving an SNDR of 67.41 dB and a bandwidth of 20 kHz. The spectrum analysis result was 10.85 ENOB when the input sinusoidal signal was 14.975 kHz. When inputted with an ECG signal, the system power consumption was as low as 0.49 μW. Furthermore, the proposed hybrid ADC obtained a good figure of merit, with FoMw and FoMs reaching 58.8 fJ/conv.steps and 164 dB, respectively. Compared to a conventional uniform sampling ADC, approximately 80% of the power savings and an 8x compression ratio can be achieved in physiological signal acquisition applications.

Fully Digital Second-order Level-crossing Sampling ADC for Data Saving in Sensing Sparse Signals

A 10-Bit 250-KS/s 1.24-uW SAR ADC for IoT Sensors with Energy-Efficient Comparator.

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 16-Channel 12-Bit Rail-to-rail Successive Approxmation Register ADC for AFEs

A Fully Dynamic 4-Channel 13b Simultaneous Sampling Incremental ΔΣ ADC Using Cascoded Floating-Inverter-Amplifier and Code Division Multiplexing Technique

A 62.2db SNDR Event-Driven Level-Crossing ADC with SAR-Assisted Delay Compensation Loop for Time-Sparse Biomedical Signal Acquisition.

A 61-nW Level-Crossing ADC With Adaptive Sampling for Biomedical Applications

A 1.2V 62.2dB SNDR SAR-Assisted Event-Driven Clockless Level-Crossing ADC for Time-Sparse Signal Acquisition

Dynamic Predictive Sampling Analog to Digital Converter for Sparse Signal Sensing

A 1V 5-bits Low Power Level Crossing ADC with OFF state in idle time for bio-medical applications in 0.18um CMOS

A 12.9-ENOB 50.6 Fj/conv.step Time-Amplitude Aligned Level-Crossing SAR ADC

A 0.49–4.34 μW LC-SAR Hybrid ADC with a 10.85-Bit ENOB and 20 KS/s Bandwidth

A Single-Ended 10-Bit 200 Ks/s 607 Μw SAR ADC with an Auto-Zeroing Offset Cancellation Technique

A Design of Low-Power 10-bit 1-MS/s Asynchronous SAR ADC for DSRC Application

A 0.9V 12-Bit 200-Ks/s 1.07µw SAR ADC with Ladder-Based Reconfigurable Time-Domain Comparator

A 12b 200KS/s SAR ADC with novel capacitor switching procedure and digital background calibration

An Ultra-Low Power Fixed-Window Level Crossing ADC for ECG Recording

A Two-Step ADC with a Continuous-Time SAR-Based First Stage

A 6.94-Fj/conversion-step 12-Bit 100-Ms/s Asynchronous SAR ADC Exploiting Split-CDAC in 65-Nm CMOS

Power Efficiency Comparison of Event-Driven and Fixed-Rate Signal Conversion and Compression for Biomedical Applications

An 8-MS/s 16-bit SAR ADC With Symmetric Complementary Switching and Split Passive Reference Segmentation in 180-nm Process