Abstract:This paper presents a level-crossing successive-approximation-register (LC-SAR) hybrid analog-to-digital converter (ADC) that combines an LC ADC with an SAR ADC, which may be used for Internet of Things (IoT) random sparse event scenarios. The sampling frequency of a traditional LC ADC is usually proportional to the maximum instantaneous rate of change of the input signal; therefore, a higher input signal frequency inevitably leads to higher system power consumption. However, the proposed hybrid ADC uses the input level difference between the two moments before and after level-crossing detection, thereby ensuring a higher conversion precision and lower power consumption, even at higher input signal frequencies. Compared with traditional LC ADC or SAR ADC, the proposed hybrid ADC combines the ultralow-power advantage of LC ADC with the high-precision advantage of SAR ADC in converting IoT data with sparse characteristics such as ECG, EEG, and brain potential. The LC-SAR hybrid ADC is designed with a 0.18 μm CMOS process and consumes 4.34 μW at a 1.8 V supply voltage, achieving an SNDR of 67.41 dB and a bandwidth of 20 kHz. The spectrum analysis result was 10.85 ENOB when the input sinusoidal signal was 14.975 kHz. When inputted with an ECG signal, the system power consumption was as low as 0.49 μW. Furthermore, the proposed hybrid ADC obtained a good figure of merit, with FoMw and FoMs reaching 58.8 fJ/conv.steps and 164 dB, respectively. Compared to a conventional uniform sampling ADC, approximately 80% of the power savings and an 8x compression ratio can be achieved in physiological signal acquisition applications.

A 0.9V 12-Bit 200-Ks/s 1.07µw SAR ADC with Ladder-Based Reconfigurable Time-Domain Comparator

A 10-Bit 250-KS/s 1.24-uW SAR ADC for IoT Sensors with Energy-Efficient Comparator.

Design of an 8-Channel 12bits 1MSPS SAR ADC

A 16-Bit 2.5-Ms/s SAR ADC with On-Chip Foreground Calibration

A 0.9 V 2.72 Μw 200 Ks/s SAR ADC with Ladder-Based Time-Domain Comparator

A 10 MS/s 10 bit SAR A/D Converter in RF System

Design of an Ultra-Low Power SAR ADC for Biomedical Applications

An 8-Bit 100ks/s Low Power Successive Approximation Register ADC for Biomedical Applications

A Low Power 12-Bit 200-Ks/s SAR ADC with a Differential Time Domain Comparator

A 10-Bit 1ms/s Low Power SAR ADC for RSSI Application

A Low Power 10-Bit 100-Ms/s SAR ADC in 65nm CMOS

A Design of Low-Power 10-bit 1-MS/s Asynchronous SAR ADC for DSRC Application

A 0.024 Mm<sup>2</sup> 4.9 Fj 10-Bit 2 MS/s SAR ADC in 65 Nm CMOS

A 0.6V 12-Bit Binary-Scaled Redundant SAR ADC with 83db SFDR

A 0.49–4.34 μW LC-SAR Hybrid ADC with a 10.85-Bit ENOB and 20 KS/s Bandwidth

A 1-V 560-Nw SAR ADC with 90-Db SNDR for IoT Sensing Applications

A 12b 200KS/s SAR ADC with novel capacitor switching procedure and digital background calibration

A 10-Bit 16-Ms/s Ultra Low Power SAR ADC for IoT Applications

A 24-µW 11-bit 1-MS/s SAR ADC with a bidirectional single-side switching technique

A 10-Bit 400-KS/s Low Noise Asynchronous SAR ADC with Dual-Domain Comparator for Input-Referred Noise Reduction