Effect of gap and overlap fiber placement defects on the delamination behavior of L-shaped composite laminates

Shimeng Qian,Xin Liu,Yaoyao Ye,Qiang Xu,Ting Zhang,Xiangqian Li

DOI: https://doi.org/10.1016/j.compstruct.2021.113963

IF: 6.3

2021-07-01

Composite Structures

Abstract:<p>This paper concerns the automated fiber placement (AFP) induced gaps and overlaps over the course of laying quasi-isotropic curved laminates. The failure of the curved composite components is generally dominated by interfacial delamination due to the relatively low out-of-plane properties of the laminates. Within this study, the effects of the gaps and overlaps on the out-of-plane tensile strength of the laminates with multidirectional plies were investigated via four-point bending tests and numerical simulation. Good agreement is obtained between the experimental and numerical results in terms of the failure loads, out-of-plane tensile strengths, and delamination locations. Results suggest that the introduction of separated or paired gaps and overlaps has little effect on the delamination-driven failure mode but influences the interaction behavior between inter-laminar delamination and intra-laminar matrix cracking.</p>

mechanics,materials science, composites