Abstract:Cu-SSZ-13 zeolite has attracted great interest owing to its extraordinary performance in the selective catalytic reduction of NOx with NH3 (NH3-SCR); however, the high expense in the costly templates for synthesizing SSZ-13 remains a serious obstacle for its application in large scale, which exacts alternative methods to get SSZ-13 of high performance in NH3-SCR at reduced cost. In this work, a series of methods, including the interzeolite conversion from X and Y zeolites (to get SZ-XC and SZ-YC, respectively) and the assistance with seed crystal and fluorine ion (to get SZ-S and SZ-F, respectively), were used to synthesize the Al-rich Cu-SSZ-13 zeolites; the influence of preparation method on the Al distribution, hydrothermal stability and catalytic performance of Cu-SSZ-13 in NH3-SCR was then comparatively investigated. The results indicate that the Cu-SSZ-13 zeolites prepared by various methods are also rather different in the content of paired Al and active Cu2+-2Al species, following the order of SZ-F > SZ-S > SZ-YC > SZ-XC; a positive correlation is observed between the catalytic activity in NH3-SCR and the content of α-Cu2+-2Al species determined by the electron spinning resonance. In particular, the Cu-SSZ-13 zeolite prepared by using fluoride as an assistant (Cu-SZ-F) has much higher fraction of paired Al and active α-Cu2+-2Al species and thereby exhibits better catalytic performance in NH3-SCR, with an NO conversion of nearly 80% at 200 °C under a gaseous hourly space velocity (GHSV) of 240,000 h−1. Moreover, the Cu-SSZ-13 zeolite prepared by the fluoride assistance method also displays less silanol defects and greater hydrothermal stability, showing enormous potential as a practicable catalyst of low cost in the elimination of NOx by NH3-SCR.

Optimizing the distribution and proportion of various active sites for better NH3-SCR property over Cu/SSZ-13

Exploring the optimal ratio of elemental components of the Cu/SSZ-13 framework: the reformation of NH<sub>3</sub>-SCR properties

In-situ synthesis of Cu-SSZ-13 catalyst: effect of Si/Al ratio on catalytic performance for NH3-SCR

A Multiple-Active-site Cu/SSZ-13 for NH3-SCO: Influence of Si/Al Ratio on the Catalytic Performance

Cu/SSZ-13 Zeolites Prepared by in Situ Hydrothermal Synthesis Method As NH3-SCR Catalysts: Influence of the Si/Al Ratio on the Activity and Hydrothermal Properties

Identification of Active Sites and Reaction Mechanism on Low-Temperature SCR Activity over Cu-SSZ-13 Catalysts Prepared by Different Methods

Redistributing Cu species in Cu-SSZ-13 zeolite as NH3-SCR catalyst via a simple ion-exchange

Study on the Performance of the Zr-Modified Cu-SSZ-13 Catalyst for Low-Temperature NH3-SCR

A New Insight into Active Cu2+ Species Properties in One‐Pot Synthesized Cu‐SSZ‐13 Catalysts for NOx Reduction by NH3

Exploring the optimal ratio of elemental components of the Cu/SSZ-13 framework: the reformation of NH 3 -SCR properties

Optimization of isolated copper species on the NH 3 -SCR performance over Cu/SSZ-39 modified by ammonia water

Improvement of Alkali Metal Resistance for NH3-SCR Catalyst Cu/SSZ-13: Tune the Crystal Size

Catalytic Activity of Cu–SSZ-13 Prepared with Different Methods for NH3-SCR Reaction

Effects of Cu species in Cu-SSZ-13 zeolites on the performance of NO x reduction reactions

Regulation of Al distributions and Cu2+ locations in SSZ-13 zeolites for NH3-SCR of NO by different alkali metal cations

A comparison of Al-rich Cu-SSZ-13 zeolites synthesized by different methods in their Al distribution, hydrothermal stability and catalytic performance in the selective catalytic reduction of NOx with NH3

A controllable zeolite framework stability of Cu/SAPO-34 via adjusting the copper coordination environment for NH 3 -SCR under hydrothermal condition

In-situ One-Pot Synthesis of Ti/Cu-SSZ-13 Catalysts with Highly Efficient NH3-SCR Catalytic Performance as Well as Superior H2O/SO2 Tolerability

Influence of Synthesis Method on Catalytic Properties and Hydrothermal Stability of Cu/SSZ-13 for NH3-SCR Reaction

Spatial Distribution of Brønsted Acid Sites Determines the Mobility of Reactive Cu Ions in the Cu-SSZ-13 Catalyst during the Selective Catalytic Reduction of NOx with NH3

One-pot synthesis of Fe/Cu-SSZ-13 catalyst and its highly efficient performance for the selective catalytic reduction of nitrogen oxide with ammonia