Abstract:Abstract As the supercritical CO2 power cycle develops and the component technologies mature, there is still a need to reduce the associated capital and operating costs to maintain a competitive levelized cost of electricity (LCOE) in order to enter the market. When considering concentrating solar power (CSP) coupled with an sCO2 power block and sensible thermal storage, the technology presents a clean source for utility-scale power generation to support baseload or peak-load electrical demand. However, the LCOE of the technology is still considered higher than the competing technologies and should be reduced to better compete in the market; 2030 targets for dispatchable solar plants are 5¢/kWh for baseload CSP and 10¢/kWh for peaker plants, as set by the United States Department of Energy. In response to this need, this study is targeting improvements in the power cycle precooler to reduce power block contribution to LCOE. This study considers a dry cooler, as CSP plants are sensitive to water consumption because many installations are slated for remote or arid locations where solar irradiance is very high, but water is scarce. Furthermore, the power block footprint for an sCO2 system is quite compact, especially as compared to a steam cycle. Therefore, there is interest in installing a more compact dry cooler that is proportional to the reduced footprint sCO2 power block, while conventional dry coolers are an order of magnitude larger. The competing goals of size, performance, and cost were considered in this study to develop a compact dry cooler that can easily be packaged with the power block, significantly reducing the installation and transport cost compared to the current state of the art, while maintaining or improving upon the heat transfer performance and impact on plant LCOE. This paper details the high-level findings of a large dry cooler sensitivity study for design point selection, design of the compact dry cooler, expected year-round performance for the dry cooler and the power cycle, and the predicted LCOE for a 30-year plant life. It was found that an aluminum heat exchanger core can be suitably designed to meet the pressure and temperature requirements for a precooler in an sCO2 recompression Brayton cycle. The dry cooler assembly was found to have improved heat transfer performance, allowing for increased cycle efficiencies and a reduced plant LCOE. When coupled with a centrifugal blower and compact transition duct, the dry cooler assembly was able to reduce the installation footprint by over 50%.

Multi-objective optimization and 4E analyses of the solar energy assisted direct-heated sCO2 power cycle for low-temperature applications

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Solar-Powered Combined Cooling, Heating, and Power Energy System with Phase-Change Material and Water Electrolysis: Thermo-Economic Assessment and Optimization

Thermo-Economic Optimization Of Supercritical Co2 Brayton Cycle On The Design Point For Application In Solar Power Tower System

Thermoeconomic analysis and optimization of a solar micro CCHP by using TLBO algorithm for domestic application

Design Optimization and Operating Performance of S-CO 2 Brayton Cycle under Fluctuating Ambient Temperature and Diverse Power Demand Scenarios

Performance Analysis and Comprehensive Evaluation of Solar Organic Rankine Cycle Combined with Transcritical CO2 Refrigeration Cycle

Comprehensive analysis of combined power cycles driven by sCO 2 -based concentrated solar power: Energy, exergy, and exergoeconomic perspectives

Multi‐objective optimization of a novel supercritical CO2 cycle‐based combined cycle for solar power tower plants integrated with SOFC and LNG cold energy and regasification

Performance analysis of solar driven combined recompression main compressor intercooling supercritical CO2 cycle and organic Rankine cycle using low GWP fluids

Performance Assessment of a Solar Tower Assisted Combined Cycle Power Plant Using Supercritical Carbon Dioxide As a Heat Transfer Fluid

Assessment of a sustainable power generation system utilizing supercritical carbon dioxide working fluid: Thermodynamic, economic, and environmental analysis

Design optimization and off-design performance analysis of one-dimensional supercritical CO 2 Brayton cycle

4E analyses and multi-objective optimization for an innovative solar-ocean thermal energy conversion/air conditioning system

Sustainable Power Generation Through Solar-Driven Integration of Brayton and Transcritical CO2 Cycles: A Comprehensive 3E (Energy, Exergy, and Exergoenvironmental) Evaluation

Development and performance analysis of a solar-powered multigeneration plant with a reheat CO2 cycle for sustainable outputs

Multi-objective optimization of supercritical CO 2 Brayton cycles for coal-fired power generation with two waste heat recovery schemes

Sensitivity analysis and exergoeconomic optimization of an improved He-CO 2 cascade Brayton cycle for concentrated solar power

Design, modeling and multi-objective techno-economic optimization of an integrated supercritical Brayton cycle with solar power tower for efficient hydrogen production

Design of a Compact Dry Cooler With an Aluminum Heat Exchanger Core for a Supercritical CO2 Power Cycle Is Evaluated for a Concentrating Solar Power Application

Techno–Economic Analysis of the Optimum Configuration for Supercritical Carbon Dioxide Cycles in Concentrating Solar Power Systems