Abstract:In micro-electrical discharge machining (micro-EDM) using the non-hollow circular cross-section tool electrode with the side flushing technique, when the aspect ratio of machined micro-hole is expected to be further increased, the discharge debris expelling speed and the working fluid renewal efficiency are weakened, which hinders the improvement of machining efficiency and accuracy with increased machining depth. In order to reveal the flow behavior of the working fluid in the micro-EDM gap, so as to realize the high-precision and high-efficiency machining of micro-hole with high aspect ratio, a three-phase flow simulation model of fluid, bubble, and debris is established in Fluent under the ideal assumption that the spark discharges occur continuously to generate high-pressure bubbles. The simulation results show that when the boundary condition of the flushing pressure at the side gap entrance is set to 0, the pressure wave emitted when the high-pressure bubble expands, which is formed by the instantaneous gasification of the working fluid between electrodes under high temperature, is the source of pneumatic force that drives the working fluid flow at the micron scale. Affected by the gap flow channel structure and the viscous resistance from inner wall, the flow velocity direction of the fluid dragging the discharge debris to rise up and expel will change, forming a dynamic alternation process of flowing into and out of the side machining gap entry. As the machining depth increases, due to the energy attenuation of the pressure wave propagating from the bottom gap to the side gap entrance, the expelling speed of the discharge debris decreases exponentially at the side gap entrance, resulting in the reduced machining efficiency and accuracy. However, when the simulated bubble generation frequency is increased to the megahertz level, the expelling efficiency of debris has a step-like improvement. The continuous and high-frequency generation of high-pressure bubbles can maintain a high pressure gradient in the bottom gap, and the discharge debris is able to continuously move upward without falling back to accumulate in the bottom gap, which is beneficial to the stable and smooth machining process, realizing the high-precision and high-efficiency machining of micro-hole with high aspect ratio.

On high resolution bubbly flow generator for gas-mixed micro electrochemical machining

Method for controlling the area of the electrolyte outlets in the flow field simulation and experimental verification of electrochemical machining

Plasma-assisted electrochemical machining of microtools and microstructures

Simultaneous gas electrical discharge and electrochemical jet micromachining of titanium alloy in high-conductivity salt solution

Electrochemical Jet Machining in Deep-Small Holes with Gas Assistance: Generating Complex Features on Internal Surfaces

Electrochemical machining of a rhombus hole with synchronization of pulse current and low-frequency oscillations

A Profile Shaping and Surface Finishing Process of Micro Electrochemical Machining for Microstructures on Microfluidic Chip Molds

Research on jet electrochemical machining with coaxial megasonic assistance

Interelectrode gas–liquid-solid three-phase flow analysis and simulation for drilling holes with high aspect ratio by micro-EDM

Machining performance enhancement of deep micro drilling using electrochemical discharge machining under magnetohydrodynamic effect

Study on Improving Electrochemical Machining Performances through Energy Conversion of Electrolyte Fluid

Investigation on pulse-vibration electrochemical machining of parallel micro-grooves

Electrochemical Machining for Micro Holes with High Aspect Ratio on Metal Alloys Using Three-Electrode PPS in Neutral Salt Solution

Research on Improvement of Accuracy of Micro ECM with Multitechnique Integration

Multiphysics Research on Electrochemical Machining of Micro Holes with Internal Features

Scanning Micro-Electrochemical Machining Process for V-Shaped Grooves

Etching uniformity study of mask electrolyte jet machining based on mass transfer coefficient: 3D simulation and experimental validation

Electrochemical discharge machining of microchannels in glass using a non-Newtonian fluid electrolyte

Sinking ECDM micro-milling of micro-channels with a customized electrode

Research On Micro Ecm Using Micro Array Electrode

Electrochemical milling of deep-narrow slots with a pulsating electrolyte flow field