Abstract:The erosion behavior of tungsten (W) exposed to low-energy, high flux deuterium (D) plasma has been investigated. The samples were characterized by scanning electron microscopy (SEM), atomic force microscopy (AFM) and ion beam analysis (IBA). The eroded thicknesses increase with increasing irradiation fluence from 4.8 × 1025 to 1.64 × 1026 m−2 for 100 eV D plasma bombardment at a temperature of approximately 600 K, however, the corresponding sputtering yields gradually decrease as a function of fluence. A number of possible erosion mechanisms for enhanced sputtering of W by D near the energy threshold which include impurities in the plasma and sample, retained D, surface roughness and morphology, were analyzed. As the sputtering threshold energy predicted by theory and simulation for deuterium on pure W is ∼216 eV and for W with carbon contamination is ∼85 eV, a sputtering yield of 2.32 × 10−6 which was measured for W with only C impurity exposed to a 60 eV deuterium fluence of 1.08 × 1026 m−2 indicates that there were a little amount of impurities such as carbon or oxygen in the D plasma but they show an important contribution to the sputtering yield of the W under 100 eV D plasma erosion. The C impurity in the sample can significantly enhance the sputtering yield of W through increasing energy transfer efficiency in a triple collision cascade system, and the change of C concentration from 14 at.% at the surface to 5.6 at.% in the deeper region of the sample dominates the change of erosion rate under 100 eV plasma bombardment. It is recommended to reducing the impurity concentration to very low levels, whether from background D plasma or contaminants in the near-surface of W wall, will be very beneficial for decreasing W erosion in Tokamak operation.

In situ measurements of low energy D plasma-driven permeation through He pre-damaged W

Reduced D Trapping by Plasma-Implanted He Nanobubbles in Radiation Damaged Tungsten

Effect of Heavy Ion Pre-Irradiation on Blistering and Deuterium Retention in Tungsten Exposed to High-Fluence Deuterium Plasma

Nanostructure Evolution and Surface Modification of Tungsten Exposed to Low Energy, High Flux Deuterium Plasma

Deuterium Retention in Heavy-Ion and Helium-Ion Sequentially Irradiated Tungsten

Dependence of blistering and deuterium retention on damage depth in damaged tungsten exposed to deuterium plasma

The effect of He-induced surface microstructure on D plasma-driven permeation through RAFM steel

Influence of Nitrogen Pre-Irradiation at Different Temperatures on Surface Blistering and Deuterium Retention in Tungsten

Deuterium retention and thermal conductivity in ion-beam displacement-damaged tungsten

Influence of radiation defects on deuterium permeation behavior in tungsten

Deuterium retention in helium-irradiated tungsten

Surface Modification and Deuterium Retention of High Energy Rate Forging W-Y2O3exposed to Deuterium Plasma

Erosion and deuterium retention behavior of tungsten exposed to impurity-seeded deuterium plasma

Irradiation hardening and deuterium retention behaviour of tungsten under synergistic irradiations of 3.5 MeV Fe 13+ ions and deuterium plasma

Microstructure Evolution and Effect on Deuterium Retention in Oxide Dispersion Strengthened Tungsten During He+ Irradiation

Microstructure and deuterium retention after ion irradiation of W–Lu2O3 composites

Blistering Behavior and Deuterium Retention in Tungsten Vanadium Alloys Exposed to Deuterium Plasma in the Linear Plasma Device STEP

Deuterium Distribution and Behavior of Blisters in Pre-Damaged and Undamaged Tungsten

Helium effects on the surface and subsurface evolutions in single-crystalline tungsten

The influence of impurities on the erosion of tungsten by low energy high flux deuterium plasma irradiation

Dependence of deuterium retention on helium ions irradiation in tungsten