Abstract:As to minimize size of the measurement system of large size and ultra-long focal length lens, two mirrors are used to change light path. In this case, installation error of the two mirrors added may be a large obstacle to accurate measurement of ultra-long focal length lens. For the sake of analyzing how installation error of two mirrors infect the angle of Moiré stripes on receiver, Moiré stripes are understood as parallel lines which composed of point light source with certain light-path vector. This approach proposed uses the calculation formula from mirror deflection angle to the reflector unit normal vector, and the matrix form of the law of reflection, to calculate the relationship matrix from vector of incident light to vector of exit light. Based on unit normal vector of two mirrors, incident light-path vector, exit light-path vector, and analytic geometry, equation of line on which image of point light source place can be presented, so we can get the angle of Moiré stripes on receiver and so is the angle error caused by installation error of the two mirrors added into light path. In addition, the angle error of Moiré stripes is calculated theoretically in 49 different situations of small mirrors deflection smaller than 1 degree. The results indicate that the installation error of the two mirrors should be taken into consideration. A new method by using autocollimator to adjust the installation error of the two mirrors is proposed, installation error of the two mirrors can be controlled to lower than 1" through this method. Moiré stripes angle error should be better than (10-4) order of magnitude in this situation. Experimental results show that Moiré stripes angle measurement error is 0.005 degree, which fully illustrates the effect of mirrors adjustment when this system is used for the measurement of ultra-long focal length.

Influence of reference sphere on test accuracy of Ritchey–Common method

Error impact analysis and experimental research for absolute testing of spherical surfaces

Aberration Calibration in High-Na Spherical Surfaces Measurement on Point Diffraction Interferometry

Error Analysis Of Spherical Ultra-Precision Measurement

Analysis on mirrors installation error of high-accuracy long focal length measurement system

Reverse Optimization Reconstruction Method in Non-Null Aspheric Interferometry

Elimination of reference surface error on high-accuracy subaperture stitching

Determination of Aspheric Vertex Radius of Curvature in Non-Null Interferometry

The Wavefront Aberration Analysis and Testing Accuracy Evaluation for the Large Aberration Aspheric System Based on the Best Fit Sphere

Method of Two-position Spherical Testing

Adjustment on the Received Optical Power of a Ground-Based Optical Instrument by a Corner Cube Retroreflector with a Curved Front-Face.

Measurement of Aspheric Surface

The wavefront aberration analysis and testing accuracy evaluation for the large aberration aspheric system based on the best fit sphere - art. no. 68342V

Retrace Error Correction for Non-Null Testing of Optical Aspheric Surface

Air Flow Turbulence Orthogonality and Surface Error Estimation in Large Aperture Optical Testing

Analysis and correction of spherical aberrations in long focal length measurements

System Optimization of Radial Shearing Interferometer for Aspheric Testing

Practical Retrace Error Correction in Non-Null Aspheric Testing: A Comparison

Improving the Accuracy of Interferometer Testing with Absolute Surface Calibration and Power Spectral Density Analysis

Correction of the error induced by obscurations of Ritchey-Chretien collimators for high-resolution space camera MTF measured with the ISO 12233 slanted-edge method

Accuracy improvement of surface measurement through phase correction in spectrally resolved interferometer