Abstract:Accurate and efficient characterization and modelling of deformation responses are critically essential in the development of advanced metal forming processes. This work presents a virtual laboratory enabled constitutive framework for modelling complex deformation responses of dual phase (DP) steels under complex stress states, based on multi-phase full-field crystal plasticity (CP) and advanced phenomenological modelling. In the CP based virtual testing method, kinematic hardening and degradation of elastic modulus are modelled in particular to improve the capability for describing evolving microstructure induced mechanical responses of DP steels. The workflow of this framework is completely built and numerically implemented, including (i) representative volume element (RVE) generation based on microstructure characterisation, (ii) identification of multiphase CP model parameters, (iii) prediction of elastic modulus degradation, (iv) prediction of yield stresses and plastic potentials in uniaxial tension and biaxial tension with various stress ratios, and (v) prediction of stress–strain curves in reverse tension compression. Using DP780 and DP980 as case materials, the corresponding physical experiments are conducted to verify the accuracy of the virtual tests, showing a good agreement between the virtual and experimental approaches. Both experimental and virtual tests are used to calibrate advanced phenomenological constitutive models that include non-linear elasticity, anisotropic yielding, and kinematic hardening. The calibrated models are implemented into the finite element (FE) codes to predict complex deformation and springback behaviours of DP780 and DP980 sheets in U-bending processes. In comparison with forming experiments of U-channel parts, the virtually calibrated models are validated and show good performance in predicting deformation and springback behaviours, providing a high capability for process analysis. The findings support that the virtual laboratory enabled modelling approach could be a substitute for extensive, expensive, and hard-to-access physically mechanical experiments required in the model calibration for a more effective and efficient analysis of metal forming processes.

Modelling the Effect of Process Conditions on Steering-Induced Defects in Automated Fibre Placement (AFP)

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Exploring Optimal Adaptive Process Parameters for Curved Infill Paths of Additive Manufactured Carbon Fibre Reinforced Polymers

An Approach for Damage Initiation and Propagation in Metal and Carbon Fiber Hybrid Composites Manufactured by Robotic Fiber Placement

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Multiscale Collaborative Optimization of Processing Parameters for Carbon Fiber/Epoxy Laminates Fabricated by High-Speed Automated Fiber Placement

Optimization of Process Parameters for Robotic Fibre Placement

Optimization of Process-Induced Residual Stresses in Automated Manufacturing of Thermoset Composites

Parametric process optimisation of automated fibre placement (AFP) based AS4/APC-2 composites for mode I and mode II fracture toughness

Efficient 3D temperature field prediction and visualization for AFP process analysis in composite structures

Defect Characteristics and Online Detection Techniques During Manufacturing of FRPs Using Automated Fiber Placement: A Review

Effective property prediction and experiment test for fiber tow composites

Machine-learning based process monitoring for automated composites manufacturing

Real-time in-situ process monitoring method based on the self-conductivity of carbon fiber prepreg for automated fiber placement (AFP)

Online Monitoring and Prediction of Thermo-Mechanics of AFP Based Thermoplastic Composites

Modeling of contact mechanics and defects investigation in automated fiber placement

Modelling the effect of gaps and overlaps in automated fibre placement (AFP)-manufactured laminates

Virtual Laboratory Enabled Constitutive Modelling of Dual Phase Steels

Experimental and numerical study on the tensile failure behavior of toughened-interlayer composite laminates with automated fiber placement (AFP) induced gap and overlap defects

Automated Fiber Placement Path Planning and Analysis of Pressure Vessels