Abstract:Induction machines (IMs) are one of the main sources of mechanical power in many industrial processes, especially squirrel cage IMs (SCIMs), due to their robustness and reliability. Their sudden stoppage due to undetected faults may cause costly production breakdowns. One of the most frequent types of faults are cage faults (bar and end ring segment breakages), especially in motors that directly drive high-inertia loads (such as fans), in motors with frequent starts and stops, and in case of poorly manufactured cage windings. A continuous monitoring of IMs is needed to reduce this risk, integrated in plant-wide condition based maintenance (CBM) systems. Diverse diagnostic techniques have been proposed in the technical literature, either data-based, detecting fault-characteristic perturbations in the data collected from the IM, and model-based, observing the differences between the data collected from the actual IM and from its digital twin model. In both cases, fast and accurate IM models are needed to develop and optimize the fault diagnosis techniques. On the one hand, the finite elements approach can provide highly accurate models, but its computational cost and processing requirements are very high to be used in on-line fault diagnostic systems. On the other hand, analytical models can be much faster, but they can be very complex in case of highly asymmetrical machines, such as IMs with multiple cage faults. In this work, a new method is proposed for the analytical modelling of IMs with asymmetrical cage windings using a tensor based approach, which greatly reduces this complexity by applying routine tensor algebra to obtain the parameters of the faulty IM model from the healthy one. This winding tensor approach is explained theoretically and validated with the diagnosis of a commercial IM with multiple cage faults.

A Proposed ABC Model for Accurate Simulation of 3-Phase Induction Motor with Inter-Turn Faults

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

Modeling and Evaluation of Stator and Rotor Faults for Induction Motors

Comparison of three composite induction motor load models

Study of Induction Motor Inter-Turn Fault Part I: Development of Fault Models with Distorted Flux Representation

Simulation and Analysis of Squirrel Cage Induction Machines under Rotor Internal Faults

Modeling of Interturn Short Fault in Interior Permanent Magnet Synchronous Motors with Multistrand Windings

Harmonic Model and Remedy Strategy of Multiphase PM Motor under Open-Circuit Fault

Fault-Tolerant Control of Five-Phase Induction Motor under Single-Phase Open

Simulation Using Matlab/Simulink On Rotor Winding Inter-Turn Short Circuit Fault In Dfig

Analytical Model of Induction Machines with Multiple Cage Faults Using the Winding Tensor Approach

On Shortening the Numerical Transient in Time-Stepping Finite Element Analysis of Induction Motor under Inter-Turn Short Circuit Fault Faults

Study of On-Line Fault Detection and Diagnostics of Three Phase Induction Motors

Fault Tolerant Control of a Multiphase Motor with Non-Sinusoidal Source under Open-Phase Conditions

An Efficient Protection Scheme Against Single-Phasing Fault for Three-Phase Induction Motor

Active fault-tolerant control for asynchronous machines using EKF-based fault estimation and 3-H-bridge inverter mitigation of ITSCs

Modeling and control of 15-phase induction machine under one phase open circuit fault

Study of Induction Motor Inter-Turn Fault Part II: Online Model-Based Fault Diagnosis Method

Inter-turn Fault Detection for the Inverter-Fed Induction Motor Based on the Teager-Kaiser Energy Operation of Switching Voltage Harmonics

Fault Diagnosis on Induction Motor using Machine Learning and Signal Processing

Short-Circuit Fault Diagnosis on the Windings of Three-Phase Induction Motors through Phasor Analysis and Fuzzy Logic