Abstract:The development of efficient sample introduction and pretreatment systems for microfluidic chip-based analytical systems is important for their application to real-life samples. In this work, world-to-chip interfacing was achieved by a novel flow-through sampling reservoir featuring a guided overflow design. The flow-through reservoir was fabricated on a 30 x 60 x 3 mm planar glass chip of crossed-channel design used for capillary electrophoresis separations. The 20-microL sample reservoir was produced from a section of plastic pipet tip and fixed at one end of the sampling channel. Sample change was performed by pumping 80-microL samples sandwiched between air segments at approximately 0.48 mL/min flow rate through the flow-through reservoir, introduced from an access hole on the bottom side of the chip. A filter paper collar wrapped tightly around the reservoir guided the overflowing sample solution into a plastic trough surrounding the reservoir and then to waste. The performance of the system was demonstrated in the separation and determination of FITC-labeled arginine, glycine, phenylalanine, and glutamic acid with LIF detection, by continuously introducing a train of different samples through the system without electrical interruption. Employing a separation channel of 4 cm (2-cm effective separation length) and 1.4-kV separation voltage, maximum throughputs of 80/h were achieved with <4.1% carryover and precisions ranging from 1.5% for arginine to 2.6% RSD (n = 11) for glycine. The sampling system was tested in the continuous monitoring of the derivatizing process of amino acids by FITC over a period of 4 h, involving 166 analytical cycles. An outstanding overall precision of 4.8% RSD (n = 166) was achieved for the fluorescein internal standard.

Direct count of fluorescent microspheres in a microfluidic chip based on capillary electrophoresis method

A Microfluid Fiber Device for Trace Detection of Aggregation Induced Emission Molecules

Three-Dimensional (3d) Hydrodynamic Focusing for Continuous Sampling and Analysis of Adherent Cells

Whole column fluorescence imaging on a microchip by using a programmed organic light emitting diode array as a spatial-scanning light source and a single photomultiplier tube as detector.

High-speed, Whole-Column Fluorescence Imaging Detection for Isoelectric Focusing on a Microchip Using an Organic Light Emitting Diode As Light Source.

Microfluidic Analysis System Based On Capillary Electrophoresis Chip

Microfluidic Chip Detection Instrument With High Signal-To-Noise Ratio

A High-Throughput Continuous Sample Introduction Interface for Microfluidic Chip-Based Capillary Electrophoresis Systems.

Studies on the Method of Flow Cytometry Integrated with Microfluidic Chip

Rapid Enrichment and Sensitive Detection of Extracellular Vesicles Through Measuring the Phospholipids and Transmembrane Protein in a Microfluidic Chip.

A Rigid Microfluidic Chip for High-Throughput Fluorescence-Activated Cell Sorting

An Automated Electrokinetic Continuous Sample Introduction System for Microfluidic Chip-Based Capillary Electrophoresis

Microfabrication of Integrated Capillary Electrophoresis Chips and On-chip Sample Injection and Separation

Fabrication of Micro/Nanofluidic Chip on Glass Substrate and Its Application for Electrokinetic Concentration of Proteins

Recent Advances in the Determination of Intracellular Contents in Individual Cells Using Microfluidic Devices

The Development of A Compact Microfluidic Chip Analyzer with Continuous Sample Introduction

Particle Counting Methods Based on Microfluidic Devices

A Chip-based Capillary Electrophoresis System for High-efficiency Bioanalysis

Sequential injection sample introduction microfluidic-chip based capillary electrophoresis system

Development of a Low-Cost Microfluidic Capillary-Electrophoresis System Coupled with Flow-Injection and Sequential-Injection Sample Introduction (Review).

A Simple Microfluidic System for Efficient Capillary Electrophoretic Separation and Sensitive Fluorimetric Detection of DNA Fragments Using Light-Emitting Diode and Liquid-Core Waveguide Techniques.