Electrocatalytic water treatment of per- and polyfluoroalkyl substances reduces adsorbable organofluorine and bioaccumulation potential

Zunhui Lin,Mahmut S. Ersan,Sergi Garcia-Segura,François Perreault,Paul Westerhoff

DOI: https://doi.org/10.1039/d4ra02448f

IF: 4.036

2024-05-15

RSC Advances

Abstract:Per- and polyfluoroalkyl substances (PFAS) are pervasive in industrial processes, eliciting public concern upon their release into municipal sewers or the environment. Removing PFAS from the environment has become an urgent need. However, because potential endpoints span from energy-intensive complete mineralization to partial PFAS transformation, understanding and developing metrics for evaluating PFAS treatment can be a challenge. The goal of this study was to evaluate and compare the effectiveness of electrocatalytic degradation of PFAS with boron-doped diamond (BDD) electrodes using four techniques: LC-MS/MS target analysis, fluoride ion (F − ), adsorbable organofluorine (AOF), and bioaccumulation potential using lipid-bilayer partition (LBP) tests. After 3 hours of electrocatalysis, >99% perfluorooctanoic acid (PFOA) degradation was achieved and corresponded with 84% conversion to F − , which was substantial – though intentionally not complete – defluorination. For the same 3 hour treatment time, AOF and LBP coefficient were reduced by 95% and 83%, respectively. LBP's detection limit was 2 orders of magnitude higher than that of AOF, so the positive correlation observed between LBP and AOF ( r = 0.86) suggests AOF's practical utility as a design metric for assessing bioaccumulation potential of various organofluorine transformation by-products.

chemistry, multidisciplinary

What problem does this paper attempt to address?

This paper attempts to address the issue of treating per- and polyfluoroalkyl substances (PFAS) in the environment. PFAS are prevalent in industrial processes and have raised public concern when discharged into municipal sewers or the environment. Removing PFAS from the environment has become an urgent task. However, the potential treatment endpoints range from energy-intensive complete mineralization to partial PFAS conversion, making it challenging to understand and develop metrics for evaluating PFAS treatment effectiveness.

The main objective of the study is to evaluate and compare the effectiveness of electrocatalytic degradation of PFAS using boron-doped diamond (BDD) electrodes through the following four techniques:
1. Liquid chromatography-tandem mass spectrometry (LC-MS/MS) targeted analysis.
2. Fluoride ion (F⁻) measurement.
3. Adsorbable organic fluorine (AOF) analysis.
4. Lipid bilayer partitioning (LBP) test to assess bioaccumulation potential.

The study found that after 3 hours of electrocatalytic treatment, the degradation rate of the main PFAS compound—perfluorooctanoic acid (PFOA)—exceeded 99%, with a conversion rate to F⁻ of 84%. Additionally, AOF and LBP coefficients decreased by 95% and 83%, respectively. The detection limit of LBP is two orders of magnitude higher than that of AOF, but the positive correlation between the two (r=0.86) suggests that AOF is a practical metric for assessing the bioaccumulation potential of various organic fluorine conversion products.