An electrocoagulation and electrooxidation treatment train to remove and degrade per- and polyfluoroalkyl substances in aqueous solution

Huanhuan Shi,Yaye Wang,Yifei Wang,Shangtao Liang,Jing Zhou,Raymond Fontanez,Shixiang Gao,Qingguo Huang,Sheau-Yun (Dora) Chiang
DOI: https://doi.org/10.1016/j.scitotenv.2021.147723
2021-09-01
Abstract:<p>This study examined the feasibility of a novel treatment train that combines electrocoagulation (EC) with electrooxidation (EO) treatment to remove and degrade per- and polyfluoroalkyl substances (PFASs) from water. Electrocoagulation with a zinc anode could effectively remove PFASs from water, and long-chain PFASs (C<sub>7</sub>–C<sub>10</sub>) tended to have a higher removal rate. Foam was generated when a relatively high current density (&gt;1 mA cm<sup>−2</sup>) was applied to a relatively high PFAS concentration (each PFAS &gt; 0.1 μM) during EC, which promoted the separation of PFASs from the bulk solution, especially for long-chain PFASs. Isotherm-like adsorption results indicated that competitive adsorption on floc occurred between PFASs when no foam was produced in a solution containing 10 different PFASs. Acid dissolution methods could recover and concentrate 10 PFASs in controlled volumes from both the floc and the foam, and it was also successfully applied in groundwater collected from a contaminated site. The concentrated PFASs in the acid solutions were efficiently destructed using EO treatment with a Ti<sub>4</sub>O<sub>7</sub> anode at 10 mA cm<sup>−2</sup>, and no supplement of electrolyte was needed for the floc dissolved solution. This electrochemical-based process can economically separate, concentrate and destroy PFASs in groundwater and wastewater.</p>
environmental sciences
What problem does this paper attempt to address?
This paper discusses the utilization of electrocoagulation (EC) and electrooxidation (EO) for the treatment of per- and polyfluoroalkyl substances (PFASs) in water. PFASs are a group of compounds with high thermal and chemical stability, widely used in various industrial and commercial products, but they have potential hazards to the environment and organisms. During the electrocoagulation process, the use of zinc anode can effectively remove PFASs from water, especially the long-chain PFASs (C7-C10). When the current density is high and the PFAS concentration is large, foam is generated, which helps in the separation of PFASs from the water, especially the long-chain ones. In addition, the study found competitive adsorption of different PFASs on the floc. Acid dissolution method can recover and concentrate PFASs from floc and foam, and is suitable for the treatment of contaminated groundwater and wastewater. Electrooxidation process uses Ti4O7 anode to efficiently destroy PFASs in acid dissolution solution without the addition of electrolyte. The main objective of the paper is to evaluate the feasibility of combining EC and EO treatment technologies for the removal and degradation of PFASs from water. Experimental results show that this electrochemical method can economically and effectively separate, concentrate, and destroy PFASs in groundwater and wastewater, providing a new strategy for the treatment of these pollutants.