Abstract:We tested a novel technology for protecting bats against wind turbines‐related mortality using a unique combination of RADAR, LIDAR and ultrasonic acoustic recorders. The drone‐mounted deterrence device produces a pulsating combination of strong auditory and visual signals while moving through the air. It differs from previously proposed solutions by being dynamic – constantly moving in the airspace and emitting constantly changing signals. LIDAR was used to assess the device's impact below flight altitude, and RADAR to assess its influence above flight altitude. High‐altitude acoustic recordings were used to describe bat activity in the research site. Analysis revealed an overall decrease in animal activity compared to baseline data and a pattern fitting increased flight altitude as a response to the deterrent. The use of this method at wind farms could save many bats annually, with implications for population viability in areas where this energy source endangers various bat species. Wind energy is a major and rapidly expanding renewable energy source. Horizontal‐axis wind turbines, the main tool in this industry, induce mortality in flying animals and consequently bring about conservation concerns and regulatory restrictions. We utilized a unique combination of RADAR, LIDAR and ultrasonic acoustic recorders to test the utility of a novel technology meant to prevent wind turbine‐related mortality in bats. Our drone‐mounted deterrent device produces a pulsating combination of strong auditory and visual signals while moving through the air. LIDAR was used to assess the device's impact below its flight altitude and RADAR to assess its influence above its flight altitude. Continuous acoustic recordings from ground level to ~400 m above‐ground‐level were used to monitor bat activity in the research site. We recorded the nightly altitudinal distributions of multiple bat species throughout the experiment. Analysis revealed a significant change in activity while the deterrent was flying compared to baseline conditions. We also recorded a significant ~40% decrease below and a significant ~50% increase above the deterrent's flight altitude during its operation compared to the post‐flight control. The tested technology is independent of wind farm activities and does not require modifying wind turbine form or operation procedures. The device differs from previously proposed solutions by being dynamic – moving in the airspace and emitting constantly changing signals – thus decreasing the probability of animal habituation. Our findings suggest that the deterrent could dramatically decrease wind turbine‐related mortality by deterring bats from approaching rotor‐swept airspace. Focused implementation in conditions where bat activity and energy production are in conflict may provide a practical, cost‐effective mortality mitigation solution compared to current alternatives. Thus, our results should be considered by the wind‐turbine industry and environmental monitoring and animal conservation organizations, as well as by regulatory agencies, when pursuing alleviation of wind turbine‐related mortality.

A passive, blade-mounted ultrasonic bat deterrent for wind turbines

Novel ultrasonic bat deterrents based on aerodynamic whistles

Frequency modulation of an aerodynamic whistle-based bat deterrent

Drone‐mounted audio‐visual deterrence of bats: implications for reducing aerial wildlife mortality by wind turbines

Acoustic-based whistle detection of drain hole for wind turbine blade

An experimental study of tonal noise from a wind turbine airfoil with flat plate serrations

Aeroacoustic investigation of a ducted wind turbine employing bio-inspired airfoil profiles

A Circularly Polarized Millimeter Wave Radar for Wind Turbine Sensing

A Feasibility Study to Reduce Infrasound Emissions from Existing Wind Turbine Blades Using a Biomimetic Technique

Aerodynamic Noise Reduction Based on Bionic Blades with Non-Smooth Leading Edges and Curved Serrated Trailing Edges

Analytical volume model for optimized spatial radar bat detection in onshore wind parks

Aerodynamic performance enhancement and noise reduction for Darrieus vertical axis wind turbines: V-shaped blades and trailing-edge serrations

Adaptive Weighted Envelope Spectrum: A Robust Spectral Quantity for Passive Acoustic Detection of Underwater Propeller Based on Spectral Coherence

Effects of an Owl Airfoil on the Aeroacoustics of a Small Wind Turbine

An experimental investigation into passive acoustic damage detection for structural health monitoring of wind turbine blades

Flexural wave modulation and mitigation in airfoils using acoustic black holes

Time-Resolved Flowfield and Acoustic Measurements of a Ducted and Unducted Rotor

Experimental determination of the dominant noise mechanism of rotating rotors using hot-wire anemometer

Numerical simulation of flow-induced noise generation and propagation of a floating offshore wind turbine with prescribed pitch motion

Development of a Linear Acoustic Array for Aero-Acoustic Quantification of Camber-Bladed Vertical Axis Wind Turbine

Leading edge erosion detection for a wind turbine blade using far-field aerodynamic noise