Effect of hot extrusion on the microstructure and mechanical properties of SiCNWs/Mg-2Zn-0.1Y composite
Wei Li,Kaibo Nie,Zhilong Liu,Kunkun Deng,Yanan Li,Xili Tong
DOI: https://doi.org/10.1016/j.matchar.2022.111970
IF: 4.537
2022-07-01
Materials Characterization
Abstract:This work investigates the effect of adding SiC nanowires (SiCNWs) on the microstructure and mechanical properties of Mg-2Zn-0.1Y matrix composites under different hot extrusion parameters, and the strengthening mechanism was analyzed. The results showed that as the extrusion temperature elevated from 140 °C to 220 °C or the extrusion speed increased from 0.1 mm/s to 1.0 mm/s, both the dynamic recrystallized grain size and the recrystallized volume fraction increased significantly. The changes of precipitate size and volume fraction exhibited the same trend. The finest recrystallized grains (~0.37 μm) were obtained after extrusion at 140 °C and 0.1 mm/s, which also contained nano-sized MgZn2 precipitates and SiC nanowires. As the extrusion temperature increased from 140 °C to 220 °C at a constant extrusion speed of 0.1 mm/s, the strength of the composites decreased while the elongation improved greatly. Similar change in the strength and elongation were obtained in the composite as the extrusion speed increased from 0.1 mm/s to 1.0 mm/s at extrusion temperature of 140 °C. Meanwhile, these composites exhibited a weakened texture, and a mixture of microcracks and dimples was observed in the fracture surfaces of the as-extruded composites, which explained the mix of brittle-ductile fractures of the composites. The composites extruded at 140 °C and 0.1 mm/s exhibited the best performance with yield strength (YS) and ultimate tensile strength (UTS) of ~495.53 MPa and ~514.18 MPa, respectively. Among all strengthening mechanisms, the proportion of grain refinement strengthening is the highest.
materials science, multidisciplinary,metallurgy & metallurgical engineering, characterization & testing