Abstract:Coral reefs thrive in complex marine geological environments and are likely to suffer from dynamic marine disasters. The liquefaction characteristics of saturated marine coral sand subjected to dynamic loading, such as ocean waves, submarine earthquakes, storm tides, volcanic activities, and hurricanes, are key factors affecting the safety of coral reefs. A systematic study is conducted through a series of hollow-cylinder torsional shear experiments on the undrained response of saturated marine coral sand with different non-plastic fines contents (FCs) under cyclic linear stress paths with various cyclic loading direction angles (& alpha;d). An interesting discovery is that the cyclic linear stress paths with angles & alpha;d and 90 degrees- & alpha;d have the same stress effect on liquefaction char-acteristics under isotropic consolidation condition. The test results show that if the near-zero effective stress state is defined as the criterion for initial liquefaction, then the liquefaction resistance of saturated coral sand de-creases with increasing & alpha;d or FC. The generation of excess pore water pressure (EPWP) presents three modes: (1) "rapid-stable-fast," (2) "rapid-stable," and (3) "fast linear-like." Moreover, an energy-based EPWP prediction method is established. A novel discovery is that the generalized shear strain amplitude (& gamma;ga) is uniquely related to the EPWP ratio of coral sand for a given relative density and FC. In addition, by introducing unit cyclic stress ratio (USR) as a new index of liquefaction resistance, a common correlation between equivalent skeleton void ratio e*sk and USR15 (required for initial liquefaction in 15 cycles) is established for all test cases considered. This is confirmed by the experimental data of five types of terrestrial siliceous sands reported in the literature.

Experimental analysis on the cyclic strength and deformation characteristics of marine coral sand under different loading frequencies

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Effects of Initial Static Shear on Cyclic Resistance and Pore Pressure Generation of Saturated Sand

Undrained Behavior of Sand under Cyclic Paths That Match Storm-Wave Loading Conditions

Advanced laboratory investigation of axial cyclic loading in silica sands

Cyclic accumulative deformation of sand and its explicit model

Influences of Cyclic Stress Paths on Deformation Behavior of Saturated Marine Coral Sand: an Experimental Study

Experimental Investigation of Liquefaction Characteristics of Saturated Coral Sand Subjected to Complex Cyclic Stress Paths: Effects of Loading Frequency

Shear Modulus and Damping Ratio of Saturated Coral Sand under Generalised Cyclic Loadings

Cyclic Failure Mechanisms of Saturated Marine Coral Sand under Various Consolidations

Experimental Study on the Generalized Dynamic Modulus of Saturated Marine Coral Sand Subjected to Different Cyclic Loading Patterns

Shear modulus and damping ratio of saturated coral sand under generalized cyclic loadings

Prediction model for generation trend of axial deformation of saturated coral sand under cyclic loading

Experimental Investigation of Cyclic Failure Mechanism of Saturated Coral Sand under Various Consolidation Conditions

Liquefaction characteristics of saturated marine coral sand with different non-plastic fines content subjected to complex cyclic stress paths

Experimental and Estimation Studies of Resilient Modulus of Marine Coral Sand under Cyclic Loading

Effects Of Cyclic Loading Directions On Liquefaction Characteristics Of Saturated Coral Sand

Experimental Study of Dynamic Shear Modulus and Damping Ratio Characteristics of Coral Sand from Nansha Islands

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Experimental study on liquefaction resistance of coral sand under complex loading conditions

Degradation properties and prediction model of maximum shear modulus of saturated coral sand under cyclic triaxial loading